User manual ECS K7S7AG13B

[. . . ] Preface Copyright This publication, including all photographs, illustrations and software, is protected under international copyright laws, with all rights reserved. Neither this manual, nor any of the material contained herein, may be reproduced without written consent of the author. Version 1. 3b Disclaimer The information in this document is subject to change without notice. The manufacturer makes no representations or warranties with respect to the contents hereof and specifically disclaim any implied warranties of merchantability or fitness for any particular purpose. [. . . ] Plug an IDE cable connector into the hard disk drive IDE connector (B). It doesn't matter which connector on the cable you use. Plug a power cable from the case power supply into the power connector on the hard disk drive (C). 2. When you first start up your system, the BIOS should automatically detect your hard disk drive. If it doesn't, enter the Setup Utility and use the IDE Hard Disk Auto Detect feature to configure the hard disk drive that you have installed. Installing a CD-ROM/DVD Drive Install the CD-ROM/DVD drive into the drive cage in your system case. If you have already installed an HDD, use the other connector on the IDE cable. Note: Ribbon cable connectors are usually keyed so that they can only be installed correctly on the device connector. If the connector is not keyed, make sure that you match the pin-1 side of the cable connector with the pin-1 side of the device connector. Each connector has the pin-1 side clearly marked. The pin-1 side of each ribbon cable is always marked with a colored stripe on the cable. Plug an IDE cable connector into the CD-ROM/DVD drive IDE connector (B). It doesn't matter which connector on the cable you use. Plug a power cable from the case power supply into the power connector on the CD-ROM/DVD drive (C). Use the audio cable provided with the CD-ROM/DVD drive to connect to the mainboard CD-in connector CD_IN1 or CD_IN2 (D). 2. When you first start up your system, the BIOS should automatically detect your CD-ROM/DVD drive. If it doesn't, enter the Setup Utility and configure the CD-ROM/DVD drive that you have installed. 17 CD_IN1 Pin 1 2 3 4 Signal Name CD IN L GND GND CD IN R Pin 1 2 3 4 CD_IN2 Signal Name GND CD IN R GND CD IN L Installing a Floppy Diskette Drive The mainboard has a floppy diskette drive (FDC1) interface and ships with a diskette drive ribbon cable that supports one or two floppy diskette drives. You can install a 5. 25-inch drive and a 3. 5-inch drive with various capacities. The floppy diskette drive cable has one type of connector for a 5. 25-inch drive and another type of connector for a 3. 5-inch drive. 1. Install the FDD into the drive cage in your system case. Plug the FDD cable into FDC1 (A): Note: Ribbon cable connectors are usually keyed so that they can only be installed correctly on the device connector. If the connector is not keyed, make sure that you match the pin-1 side of the cable connector with the pin-1 side of the device connector. Each connector has the pin-1 side clearly marked. [. . . ] The mainboard identification is located in the upper left-hand corner. 4. Check the box next to the items you want to install. An item installation screen appears: 5. Follow the instructions on the screen to install the items. Drivers and software are automatically installed in sequence. Follow the onscreen instructions, confirm commands and allow the computer to restart a few times to complete the installation. 39 Manual Installation Insert the CD in the CD-ROM drive and locate the PATH. DOC file in the root directory. [. . . ]