User manual EDIROL S-0816 BROCHURE

[. . . ] Digital Audio Transfer System Compact, Portable Digital Snake System S-1608 S-0816 Stage Unit FOH Unit REAC - The Audio Quality Sta Analog Output Terminals On board 24bit/96kHz DA converters. Analog Input Terminals On board 24bit/96kHz AD converters and high quality mic pre-amps with phantom power supply. S-1608 The snake comes with high quality pre-amp Unlike analog multicore snake cables, RSS Digital Snake systems are equipped with high quality and remote-controllable mic pre-amps. [. . . ] By using Cat5e cable instead of large multi-core copper cable, the S-1608/0816 digital snake system is immune to the ìhums and buzzesî caused by electrical noise and ground issues. ndard for Digital Snake Systems REMOTE Terminal (RS-232C) Connector for either the dedicated remote controller (S-4000R) or computer installed with S-4000-RCS remote control software. Digital Output (Optical) Output the audio signal input to INPUT 1/2 of the S-1608/ 0816 for monitoring sync. Mute All Output Button When this button is pressed and held, all outputs in the system will be muted. Mode Selection Switch Master Slave Split Outputs source audio to the Slave and Split devices It receives Input from the Slave device. Receives Input from and sends output to the Master device. Receives Input from all of the Master deviceís sources. S-0816 Easy and Expandable 32 x 16 setup STAGE S-1608 16 inputs 8 output s S-1608 16 inputs 8 output s S-0816 S-0816 16 inputs FOH Unit The S-1608/0816 Digital Snake system is ideal for bands, corporate A/V events, seminars, rental and staging houses, House of Worship and broadcasters that needs the best possible sound quality from their audio without the high frequency losses and bulk of analog snakes. Remote-controllable Front of House S-4000R or S-4000RCS provide easy remote control of all input gain adjustment, phantom power and PAD settings. 8 output s 8 output s Master Console 16 inputs 32 x 16 setup with split MONITOR STAGE S-1608 S-0816 16 inputs 16 inputs 8 output s S-0816 16 inputs 16 inputs Monitor Console S-1608 16 inputs 8 outputs S-0816 REAC Splitter 8 output s 16 inputs 8 outputs Front of House S-0816 16 inputs REAC technology will make easy recording split Because REAC is based on standard Ethernet technology, the individual audio inputs coming into S-1608/0816 digital snake system can be recorded via the Gigabit Ethernet port of PC computer. DAW software to capture the audio signal is now under development by Cakewalk and will be released in the near future. This will make multi-channel live recording easier than ever before. 16 inputs Master Console Specifications Number of Channels AD and DA Conversion Frequency Response Total Harmonic Distortion + Noise Dynamic Range Cross Talk Nominal Input Level PAD Input Impedance Nominal Output Level Output Impedance Recommended Load Impedance Residual Noise Level (IHF-A, typ. ) Equivalent Input Noise Level Network Latency Connectors S-1608 : 16 in 8 out S-0816 : 8 in 16 out 24 bit / 96 kHz -2 dB / +0 dB (@ +4 dBu, 20 Hz to 20 kHz) 0. 05 % or less (Pad: On, Input Gain: +4 dBu, 22Hz to 20 kHz) 110 dB -80 dB or less (Input Gain: +4 dBu, typ. ) -65 to -10 dBu (PAD: Off), -45 to +10 dBu (PAD: On) (1 dB step, Max. +28 dBu) 20 dB On/Off 14 k ohms +4 dBu, Max. +22 dBu 600 ohms 10 k ohms or greater -80 dBu or less S-1608: -128 dB S-0816: -124dB 375 microseconds when using REAC cable only (*1) (AD>REAC>DA Latency: approx 1. 2 ms) S-1608 : Analog Input x 16 (XLR type, balanced, phantom power) Analog Output x 8 (XLR type, balanced) Digital Output connector x 1 (Optical type) REAC Connector x 1 (RJ-45 EtherCon type) Remote Connector x 1 (RS-232C, DB-9 type) S-0816 : Analog Input x 8 (XLR type, balanced, phantom power) Analog Output x 16 (XLR type, balanced) Digital Output connector x 1 (Optical type) REAC Connector x 1 (RJ-45 EtherCon type) Remote Connector x 1 (RS-232C, DB-9 type) POWER Indicator x 1, REAC Indicator x 1, REMOTE Indicator x 1, MUTE ALL OUTPUTS Indicator x 1 AC 115 V, AC 117 V, AC 220 V, AC 230 V, AC 240 V (50/60 Hz) 45W Phantom Power Dimensions Weight Operation Temperature Accessories +48 V / 14 mA (each input, remote controlled) 401 (W) x 135 (D) x 177 (H) mm or 15-13/16 (W) x 5-3/8 (D) x 7 (H) inches 5. 5 kg 12 lbs 3 oz 0 to +40 degrees Celsius +32 to +104 degrees Fahrenheit Power Cord x 1, REAC Connector Cover x 1, Ferrite Cores x 1 Rubber Foot x 4, Rack Mount Kit x 1, Owner's Manual Indicators Power Supply Power Comsumption *1: When a REAC Splitter S-4000-SP or a switching hub is used in-line with REAC cables, the network latency will increase by the amount of processing delay introduced by the splitting device itself. The actual delay is dependant upon the specifications of the splitting device, though the maximum delay amount for a single splitting device should be about 200 microseconds. [. . . ] All specification and appearances are subject to change without notice. [. . . ]