User manual EDOBE XDOM PAIR OF SPEAKERS

[. . . ] Use only with portable table lamps in which the distance from the bottom of the base to the top of the lampholder does not exceed three (3) times minimum base width. Use only with portable table lamps which are provided with lamp shades or the equivalent. This device is not intended for use with emergency exit fixtures or emergency exit lights 11. Congratulations Thank you for choosing a LightSpeaker® from ebode electronics. [. . . ] Then choose the fixtures that are most evenly spaced to your preferred listening position. Turn off circuit breakers to all lighting fixtures you are working on! A) Turn off the circuit breaker and light switch, to the bulb you intend to replace with a LightSpeaker®. Your ebode electronics LightSpeaker® is designed to fit into a standard E27 socket. It will not fit any other type connector. Your LightSpeaker® is designed to fit directly into most recessed fixtures, table lamps and pendants by simply removing the existing light and, in the same manner as a light bulb, re-installing your LightSpeaker® in its place. Because of all the technology packed into LightSpeaker®, it is much larger than a normal light bulb, both in length and width. The best way to use Lightspeaker® is in a fitting where you cannot actually see the sides of the product at all. As long as the front grille is unrestricted so you can hear the music and see the light, you do not really want to see where the sound and light comes from. In general this means that the ideal is a long, slim lampshade rather than one short and wide. Please give this some thought when choosing a fitting for your LightSpeaker®. Please note - between the front edge of the E27 socket in your fitting and the front grille of LightSpeaker® you need to have a shade/fitting that will be at least 15 cm long and 14 cm wide At www. Eu you can find a selection of lampmodels that will work with LightSpeaker®. A) Set the zone switch on the back of the LightSpeaker® to one, unless you are setting up a two zone system. If you are installing more than one pair of LightSpeakers® you will probably want to divide your home into zones. 1) While holding the LightSpeaker® in the palm of your hand rotate the unit until one of the holding tabs is facing up. 2) Using a fingernail, common screwdriver or other small flat object, gently push down and then out on the tab, easing it out through the opening in the LightSpeaker® housing. CAUTION: Do not touch the LED or Speaker Baffle with the lens off when the unit is hot, allow the unit to cool down before touching the baffle. [. . . ] A factory return authorization number will be sent to you. Do not return any unit without first receiving written authorization and shipping instructions from your dealer. There are no other warranties, including without limitation, either express or implied warranties of merchantability or fitness for a particular purpose, with respect to the product. repair or replacement as provided under this warranty is the exclusive remedy of the consumer/purchaser. [. . . ]