User manual EFD 2400

[. . . ] Ultra® 2400 Series Dispensing Workstation User's Guide Electronic pdf files of EFD® manuals are also available at www. efd-inc. com/manuals. html. Ultra 2400 Ultra 2405 Ultra 2415 ® A NORDSON COMPANY Introduction Welcome to the Ultra 2400 Series, the most complete dispensing system on the market. This User's Guide will help you maximize the usefulness of your new workstation. Please spend a few minutes to become familiar with the controls and features. Follow our recommended testing procedures. [. . . ] Push the air pressure knob in to lock setting. Remember - always bring the tip in contact with the work surface at the illustrated angle. After the tip is in position, press the foot pedal. Release pedal and remove tip by lifting straight up. 45º Correct angle for consistent deposits. 16 Initial Test Procedures Testing in Timed Mode · · · · · · Follow steps in "Testing in Steady Mode" to purge your dispensing tip with fluid. Rest the dispense tip on the Dot Standards sheet. Press the foot pedal (or finger switch) to activate the dispense cycle. Note: the pedal only needs to be pressed for a moment. The complete time will run once you activate the dispense cycle. Changing the time changes the deposit size. If your dot is too small, increase the dispense time to increase the deposit size. If your dot is too large, decrease the dispense time to decrease your deposit size. Testing in Teach Mode · · · · · · · Follow steps in "Testing in Steady Mode" to purge your dispensing tip with fluid. Rest the dispense tip on the Dot Standards sheet. Press the foot pedal to establish your dot size. Tapping the foot pedal repeatedly will have a cumulative effect on the dot size and dispense time. Continue to press the foot pedal until you achieve the correct deposit size. Save the dispense time setting you just created by pressing SAVE. This automatically exits TEACH mode and returns you to TIMED mode. If needed, press CLEAR to start over. If you have any questions at this point, please call us now. In the USA, call 800-556-3484 between 8:30 a. m. In Europe, call +44 (0) 1582 666334 In Asia, call +86 (21) 5854 2345 In all other areas, call your authorized EFD distributor or +1-401-434-1680. 17 Memory The Ultra 2400 dispensing workstation allows you to store the dispense time, pressure and vacuum settings for up to 16 different job programs. Programs are saved even with power removed and will remain in storage unless changed or erased intentionally. Job programs are identified as Memory 1 through Memory 16. Note: Dispense time is automatically adjusted when you select an individual job program. Settings for pressure and vacuum are stored and can be displayed but you need to manually adjust the pressure and vacuum regulator knobs to match the stored settings for these values. To Save a Job Program 1. [. . . ] Fits all sizes of syringe barrels from 3cc to 55cc. Specify EFD part #2440FS. Workstation lamp Helpful work lamp is mounted on a flexible arm, can be adjusted to multiple positions and provides targeted lighting to help operators work with greater accuracy and comfort. Specify EFD part #2437. Safety shield Large, acrylic safety shield is mounted on a flexible arm and can be adjusted to multiple positions. Provides splash guard protection in areas where adhesives and toxic fluids are used. [. . . ]