User manual EIKI LC-XT1

[. . . ] MULTIMEDIA PROJECTOR MODEL LC-XT1 OWNER'S INSTRUCTION MANUAL LC-XT1 TO THE OWNER Before operating this projector, read this manual thoroughly and operate the projector properly. This projector provides many convenient features and functions. Operating the projector properly enables you to manage those features and maintains it in better condition for a considerable time. Improper operation may result in not only shortening the product-life, but also malfunctions, fire hazard, or other accidents. [. . . ] Another dialog box INPUT SOURCE Menu will appear. the POINT DOWN button and a red-arrow icon will appear. Move the arrow to "RGB", and then press the SELECT button. 2 Press RGB When connect the computer output Type (Red, Green, Blue, Horiz. Sync. )] from the computer to the A/Pr, G/Y, B/Pb, H/HV and V jacks. . LC-XT1 . LC-XT1 . LC-XT1 This Projector can automatically tune to the display signals from most personal computers currently distributed. However, some computers employ special signal formats which are different from the standard ones and may not be tuned by the Multi-Scan system of this projector. If this happens, the projector cannot reproduce a proper image and the image may be recognized as a flickering picture, a non-synchronized picture, a non-centered picture or a skewed picture. This projector has a PC ADJUSTMENT function to enable you to precisely adjust several parameters to match with those special signal formats. This projector has 8 independent memory areas to memorize those parameters manually adjusted. This enables you to recall the setting for a specific computer whenever you use it. NOTE: This PC ADJUSTMENT function cannot be operated when the input signal is digital from the DVI terminal or "RGB" is selected on the SYSTEM MENU (P28 and 29). 1 Press the MENU button and the ON-SCREEN MENU will appear. Press the POINT RIGHT/LEFT button to select PC ADJUST and press the SELECT button. Another dialog box "Where to reserve" Menu will appear. In this dialog box, you can store the parameter into the area from "Mode 1" to "Mode 8. " When memorizing the new computer parameter, select the Mode with the message "Free" by pressing the POINT UP/DOWN button and the SELECT button. To change the parameters of the Mode previously set, select the Mode with "Stored. " When the Mode is selected, Parameter adjustment dialog box appears. Move the arrow to the item that you want to change by pressing the POINT UP/DOWN button, and adjust each item by pressing the SELECT button to match with your computer. Move the arrow to "Stored" and press the SELECT button. The parameter is memorized in the selected Mode. activate the Mode manually adjusted in this PC ADJUSTMENT Menu, select the Mode at the SYSTEM SELECT Menu. (Refer to page 28. ) 2 3 4 5 To . LC-XT1 Total lines The number of the total vertical lines. Adjust the number to match the image of your personal computer. Total dots The number of the total dots in one horizontal period. Adjust the number to match the image of your computer. Horizontal I Vertical Adjustment of the horizontal or vertical picture position. When the image is not centered on the screen, adjust each of those items. Clamp Adjustment of the clamp level. [. . . ] And when any of 2 lamps are out, the projector operates with 1 lamp. Lamp Mode can be switched to 4 lamps or 2 lamps manually. Refer to SETTING section on page 39, 40. . LC-XT1 Follow these steps to replace the lamp assembly. 1 2 3 4 5 6 7 8 Check the number of lamp to be replaced on Lamp Status Display. Turn off the projector and disconnect the AC Power Cord. [. . . ]