User manual EINHELL BG-AW 1140 N

[. . . ] The operator is responsible for complying with local safety and installation regulations. (Ask an electrician if you are in any doubt. ) Consequential damage caused by flooded rooms in the event of the equipment suffering faults must be prevented by the user by means of suitable measures (for example installing alarm systems or a reserve pump, etc. In the event of a failure, repair work may only be carried out by an electrician or by ISC after sales service personnel. [. . . ] Avoid positioning the suction pipe higher than the pump, as this would delay the escape of air bubbles from the suction pipe and impede the priming process. Install the intake and discharge lines in such a way that they do not exert any mechanical pressure on the equipment. The intake valve should be low enough in the water to ensure that if the water level falls, the equipment will not run dry. A leaking intake line will draw in air and therefore not draw in any water. 3 Connecting the discharge line The discharge line (min. 3/4") must be connected to the 1" female thread discharge line connector of the equipment either directly or with the aid of a threaded nipple. With the right couplings it is also possible, of course, to use a 1/2" delivery hose. the smaller delivery hose results in a lower delivery rate. During the priming operation, fully open any shut-off mechanisms (spray nozzles, valves, etc. ) in the pressure line so that the air can escape without obstruction. The pump is switched off automatically by the thermostat if overheating occurs and is switched on again automatically after cooling. If the automatic domestic water system is connected directly to a pressurized water line, the pump simply needs to be switched on. The pump then starts running automatically when the water tap or spray nozzle is opened and stops automatically when the tap or nozzle is closed. The automatic domestic water system switches off only if the water flow is stopped 100 percent. Fill the pump housing with water via the water filler screw (2). The intake process starts automatically; water can be suctioned in for up to 5 minutes (maximum suction height). All operating states are indicated by LEDs on the front of the equipment. The green (Power) and yellow (On) diodes illuminate as soon as the equipment is connected to the power supply. the yellow diode indicates that the pump is in operation. The pump runs for a few seconds to fill the delivery system with water and establish the required pressure. The initial intake process can last 30 seconds to 5 minutes, depending on the suction height and volume of air in the intake line. The pump should be refilled with water if this time is exceeded. [. . . ] In the unlikely event that your device develops a fault, please contact our service department at the address shown on this guarantee card. Of course, if you would prefer to call us then we are also happy to offer our assistance under the service number printed below. Please note the following terms under which guarantee claims can be made: 1. These guarantee terms cover additional guarantee rights and do not affect your statutory warranty rights. [. . . ]