User manual EINHELL BG-CG 7.2 LI

[. . . ] The equipment may only be used for the tasks it is designed to handle. Any other use is deemed to be a case of misuse. The user / operator and not the manufacturer will be liable for any damage or injuries of any kind caused as a result of this. Please note that our equipment has not been designed for use in commercial, trade or industrial applications. [. . . ] Make sure that there are no foreign bodies in or alongside the hedge, which could damage the blades. When to cut hedges: As a general rule: hedges which loose their leaves in the autumn should be cut in June and October. Evergreen hedges can be cut in April and August. Once you have removed the blade you will be able to see the toothed wheels of the gear unit (Fig. Make sure that no dirt gets into the gear unit when you change the blade. 8/Item 1) into position so that the pin for the eccentric connector and the eccentric mount fit together precisely when assembled. 9/Item 1) on the grass cutter blade to the left or the right to find the position at which the pin for the eccentric connector (Fig. That grass residues and dirt is removed also from the top and bottom blades. Because of the risk of injury or damage to property, never clean the product with running water, especially not with a pressure hose. 2 Servicing For good cutting performance the blades should always be sharp. They can therefore be resharpened with a whetstone. in particular we recommend to remove notches and ridges which are produced on the blades by stones or the like. There are no parts inside the equipment which require additional maintenance. 3 Ordering replacement parts: Please provide the following information on all orders for spare parts: Model/type of the equipment Article number of the equipment ID number of the equipment Spare part number of the required spare part For our latest prices and information please go to www. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the equipment immediately after you use it. Clean the appliance regularly with a damp cloth and some soft soap. Do not use cleaning agents or solvents; these may be aggressive to the plastic parts in the appliance. ensure that no water can get into the interior of the tool. The shears should be cleaned thoroughly every time before and after use. A few drops of oil (for example sewing machine oil) applied to the blades improve the cutting performance. [. . . ] In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]