User manual EINHELL BG-DP 6015 N

[. . . ] In stagnant water bodies, garden ponds, swimming ponds and their surrounding areas the unit may only be used with an earth-leakage circuit breaker with an actuating rated current of up to 30 mA (according to VDE 0100 Part 702 and 738). The equipment is not designed for use in swimming pools and paddling pools of any kind or other bodies of water in which people or animals may be present during operation. This equipment is not designed to be used by people (including children) with limited physical, sensory or mental capacities or those with no experience and/or knowledge unless they are supervised by a person who is responsible for their safety or they have received instructions from such a person in how to use the equipment safely. Children must always be supervised in order to ensure that they do not play with the equipment. [. . . ] If the distance is too small, there is no guarantee that the equipment will work correctly. When adjusting the floating switch, make sure that the floating switch does not touch the bottom before the equipment is switched off. Size of foreign bodies: Switching point height: ON Switching point height: OFF Before putting the equipment into operation 5. 1 Installation The equipment can be installed either: Stationary with rigid tubing or Stationary with a flexible hose line Note!When installing, never hang the equipment by the discharge line or by the power cable. The equipment must be hung up with the provided carry handle or it must rest on the bottom of the shaft. To ensure that the equipment works properly, the bottom of the shaft always must be free of sludge and other accumulations of dirt. If the water level is too low, the sludge in the shaft can quickly dry out and hinder the equipment from starting. It is necessary therefore to check the equipment regularly (carry out trial startups). Note: The pump shaft should measure at least 40 x 40 x 50 cm so that the floating switch can move freely. 2 Mains connection The equipment you have purchased comes with an earthing-pin plug. the equipment is designed for connection to a socket outlet with earthing contact for 230 V ~ 50 Hz. Make sure that the socket-outlet is sufficiently fused (at least 6 A) and in good working If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. Unplug the power plug prior to any maintenance work. For mobile applications, the equipment should be cleaned with clear water after every usage. For stationary installation, it is recommended that you check the floating switch for proper functioning every three months. Use a water jet to remove any lint or fibrous particles that may have become trapped in the housing. Remove sludge from the shaft bottom and clean the shaft walls every 3 months. Use clear water to remove deposits from the floating switch. 1 Cleaning the paddle wheel If a lot of deposits collect in the housing, the bottom part of the equipment must be dismantled as follows: 1. Clean the paddle wheel with clear water. Do not put down or rest the equipment on the paddle wheel! [. . . ] Guarantee claims should be submitted before the end of the guarantee period within two weeks of the defect being noticed. no guarantee claims will be accepted after the end of the guarantee period. The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. [. . . ]