User manual EINHELL BG-GP 1146 NM

[. . . ] do not expose the equipment to a direct jet of water. The operator is responsible for complying with local safety and installation regulations. (Ask an electrician if you are in any doubt. ) Consequential damage caused by flooded rooms in the event of the equipment suffering faults must be prevented by the user by means of suitable measures (for example installing alarm systems or a reserve pump, etc. [. . . ] 3/4" plastic hose with spiral reinforcement) either directly or with a threaded nipple to the pumps intake connection (1" IG) (see Fig. If the intake valve cannot be used, a check valve should be installed in the intake line. Position the intake line so that it rises from the water withdrawal point to the equipment. Avoid positioning the suction pipe higher than the pump, as this would delay the escape of air bubbles from the suction pipe and impede the priming process. Install the intake and discharge lines in such a way that they do not exert any mechanical pressure on the equipment. The intake valve should be low enough in the water to ensure that if the water level falls, the equipment will not run dry. A leaking intake line will draw in air and therefore not draw in any water. If necessary, install a prefilter for this purpose. 2 Connecting the discharge line The discharge line (min. 3/4") must be connected to the 1" female thread discharge line connector of the equipment either directly or with the aid of a threaded nipple. With the right couplings it is also possible, of course, to use a 1/2" delivery hose. the smaller delivery hose results in a lower delivery rate. During the priming operation, fully open any shut-off mechanisms (spray nozzles, valves, etc. ) in the pressure line so that the air can escape without obstruction. The pump is switched off automatically by the thermostat if overheating occurs and is switched on again automatically after cooling. 2) The garden pump is equipped with a pull-out transport handle and wheels to make it easier to transport. pull out the pull-out transport handle as far as it will go. The pump can now be pulled along with ease. After transport, push the pull-out transport handle back in again. 1 Servicing If the equipment becomes clogged, connect the discharge line to the water line and disconnect the suction hose. Replacing the mains cable: Important: Disconnect the equipment from the power supply! a defective mains cable may only be replaced by a qualified electrician. [. . . ] Of course, if you would prefer to call us then we are also happy to offer our assistance under the service number printed below. Please note the following terms under which guarantee claims can be made: 1. These guarantee terms cover additional guarantee rights and do not affect your statutory warranty rights. We do not charge you for this guarantee. [. . . ]