User manual EINHELL BG-PM 51 M-SE

[. . . ] Vor Inbetriebnahme Bedienungsanleitung und Sicherheitshinweise lesen und beachten Read and follow the operating instructions and safety information before using for the first time. Störung Unruhiger Lauf, starkes vibrieren des Gerätes mögliche Ursache - Schrauben lose - Messerbefestigung lose - Messer unwuchtig Motor läuft nicht - Bremshebel nicht gedrückt - Gashebel falsche Stellung - Zündkerze defekt - Kraftstofftank leer - Benzinhahn geschlossen Motor läuft unruhig - Luftfilter verschmutzt - Zündkerze verschmutzt Rasen wird gelb, Schnitt unregelmäßig - Messer ist unscharf - Schnitthöhe zu gering - Motordrehzahl zu gering Grasauswurf ist unsauber - Motordrehzahl zu gering - Schnitthöhe zu niedrig - Messer abgenutzt - Fangsack verstopft Behebung - Schrauben prüfen - Messerbefestigung prüfen - Messer ersetzen - Bremshebel drücken - Einstellung prüfen - Zündkerze erneuern - Kraftstoff einfüllen - Benzinhahn öffnen - Luftfilter reinigen - Zündkerze reinigen - Messer schärfen - richtige Höhe einstellen - Hebel auf max. Safety regulations Layout Intended use Technical data Before starting the equipment Operation Cleaning , maintenance, storage, transport and ordering of spare parts 8. When using the equipment, a few safety precautions must be observed to avoid injuries and damage. [. . . ] Deposits not only make it more difficult to start the mower; they decrease the quality of the cut and make it harder for the machine to bag the grass. Always mow along inclines (not up and down). Slightly turning the front wheels up the hill while mowing will prevent the mower from sliding out of the straight line. select the cutting height according to the length of the grass. If the lawn has grown quite a bit, mow over it several times so that no more than 4 cm of grass are cut at one time. Switch off the engine before doing any checks on the blade. Keep in mind that the blade continues to rotate for a few seconds after the engine has been switched off. Immediately switch off the lawn mower and wait for the blade to come to a complete stop. Then inspect the condition of the blade and the blade mount. Pay attention to ensure that you do not run into or over anything that could damage the mower. The lawn mower could be damaged and/or the machine could inflict bodily injury. A hot engine, exhaust or drive unit can burn the skin if touched. Thus, do not touch these parts unless the mower has been switched off for a while and you know that they have cooled down!Use extra caution when mowing on inclines and steep grades. Insufficient daylight or even a sufficient level of artificial light is one reason not to mow. Check the mower, the blade and other parts if they have struck a foreign object or if the machine vibrates more than usual. Do not make any adjustments or repairs until the engine has been switched off. Pay special attention if you are mowing directly next to a street or are close by one (traffic). Always keep the grass chute pointed away from the street. Avoid mowing in places where the wheels have trouble gripping or mowing is unsafe in any other way. Before you back up, ensure that nobody is standing behind you (especially little children, who are more difficult to see). When mowing over thick, high grass, select the highest cutting level and mow at a slower speed. [. . . ] Of course, if you would prefer to call us then we are also happy to offer our assistance under the service number printed below. Please note the following terms under which guarantee claims can be made: 1. These guarantee terms cover additional guarantee rights and do not affect your statutory warranty rights. We do not charge you for this guarantee. [. . . ]