User manual EINHELL BG-US 2.5

[. . . ] do not use the spreader material compartment to store unneeded spreader material. Clean the spreader material compartment before filling. Make sure that the ON/OFF switch is not activated before you remove any blockages, clean the equipment, perform any maintenance or place the equipment in storage. Never remove blockages with your fingers - use a stick or a similar tool. [. . . ] If the equipment is not used for a lengthy period of time, remove the batteries from the equipment to prevent them leaking. The equipment may only be used for the tasks it is designed to handle. Any other use is deemed to be a case of misuse. The user / operator and not the manufacturer will be liable for any damage or injuries of any kind caused as a result of this. Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the equipment is used in commercial, trade or industrial businesses or for equivalent purposes. 1 / Item 2) Each spreader material is supplied with instructions on how many grams per square meter are to be spread. set a low flow rate for smaller quantities and increase the flow rate for larger quantities. The following settings are recommended: Setting 1: fine grass seeds Setting 2: coarse grass seeds Setting 3: light fertilizer Setting 4: heavy fertilizer Setting 5: pearled fertilizer or de-icer Note: Numerous variable factors (such as walking speed, working height, motor speed etc. ) do not allow a specific recommendation of the spreading setting. Rather, the optimal setting must be determined by the user when starting with the work. 1/3) Note: The ON/OFF switch (6) activates the opening for the spreader material as well as the spreader wheel. You cannot actuate the ON/OFF switch (6) until you have pushed back the switch lock (1). The switch lock may become detached if you fail to observe this point. Ensure that the ON/OFF switch (6) is not activated and that the infinitely adjustable speed controller (5) is set to position "0". Place the spreader on a paved surface and fill spreading material into the spreading material Area coverage: Spreading width: Spreader material compartment volume: LWA sound power level: LpA sound pressure level: Vibration aw: Weight excluding batteries: 6 V DC 4 x Mignon (AA) 750 m2 0. Insert the batteries before using for the first time (Fig. Be sure to observe the correct polarity (+/-) of the batteries. Set the required spreading width using the speed controller (5). Push back the switch lock (1) and activate the ON/OFF switch (6). After carrying out work on a small area, adjust the settings if necessary. The raw materials in this packaging can be reused or recycled. [. . . ] no guarantee claims will be accepted after the end of the guarantee period. The original guarantee period remains applicable to the device even if repairs are carried out or parts are replaced. In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used. [. . . ]