User manual EINHELL BT-LS 65 U

[. . . ] Anleitung_BT_LS_65_U_SPK1:_ 12. 11. 2008 11:11 Uhr Seite 1 Bedienungsanleitung Holzspalter Operating Instructions Wood Splitter Mode demploi Fendeur de bois Istruzioni per luso Spaccalegna Brugervejledning Brændekløver Bruksanvisning Vedklyv B f 4 j W Upute za uporabu Sjekac drva Uputstva za rukovanje Cepac drva Návod k obsluze Stípacka deva Návod na obsluhu Stiepacka dreva Art. -Nr. : 34. 321. 60 I. -Nr. : 01018 BT-LS 65 U Anleitung_BT_LS_65_U_SPK1:_ 12. 11. 2008 11:12 Uhr Seite 2 1 3 2 1 4 5 7 6 2 8 9 10 11 12 3 16 16 13 14 19 20 21 15 17 2 18 26 28 27 22 23 24 25 Anleitung_BT_LS_65_U_SPK1:_ 12. 11. 2008 11:12 Uhr Seite 3 4 19+20+21 11 19+20+21 26+27+28 12 21+20+19 15 8 28+20+19 21+20+19 10 13 14 9 18 16 17 5 6 15 24+25 23+24 22 15 24+25 22 23+24 22 22 8 3 Anleitung_BT_LS_65_U_SPK1:_ 12. 11. 2008 11:12 Uhr Seite 4 7 8 16 17 18 17 9 10 4 11 12 B A C 4 Anleitung_BT_LS_65_U_SPK1:_ 12. 11. 2008 11:12 Uhr Seite 5 13 E 14 F G 15 16 H 5 Anleitung_BT_LS_65_U_SPK1:_ 12. 11. 2008 11:12 Uhr Seite 12 GB Table of contents 1. Cleaning, maintenance and ordering of spare parts 8. Troubleshooting 12 Anleitung_BT_LS_65_U_SPK1:_ 12. 11. 2008 11:12 Uhr Seite 13 GB Important!When using equipment, a few safety precautions must be observed to avoid injuries and damage. [. . . ] Wait a few seconds for the motor to start up and air to be built up in the hydraulic pump. 12/Item C) sideways with the other hand. 1/Item 3) will then apply pressure to the trunk and press it against the wedge (Fig. Once the trunk has been split, release the operating handle (Fig. 12/Item C) so that the trunk pusher (Fig. If the trunk fails to split immediately, never attempt to force it to split by maintaining the pressure for more than a few seconds. It is far more advisable to try and reposition the trunk on the splitter or to remove the trunk altogether and place it to one side. By doing this you will make sure that you have a safe area in which to work because you will keep it clear of obstacles and prevent any risk of tripping over or of the power cable becoming damaged. Do not forget to retighten the ventilation screw (Fig. 10/Item 4) when you have finished your splitting work. 6. 3 HOW TO RELEASE A TRUNK WHICH GETS STUCK 1. Release both operating handles so that the trunk pusher (Fig. Insert a triangular shaped wooden wedge under the trunk and then start the trunk pusher to press the wedge under the stuck trunk. Repeat this process with larger and larger wedges until the stuck trunk is released. Never hammer against the stuck trunk or place your hands anywhere near the trunk when trying to release it. NEVER ASK ANYONE ELSE TO HELP WHEN TRYING TO RELEASE A TRUNK WHICH HAS BECOME STUCK. NEVER ATTEMPT TO RELEASE THE TRUNK BY HITTING IT WITH A TOOL. Anleitung_BT_LS_65_U_SPK1:_ 12. 11. 2008 11:12 Uhr Seite 15 GB 7. Cleaning, maintenance and ordering of spare parts Always pull out the mains power plug before starting any cleaning work. 7. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Clean the equipment regularly with a moist cloth and some soft soap. [. . . ] Ask your dealer or your local council. 15 Anleitung_BT_LS_65_U_SPK1:_ 12. 11. 2008 11:12 Uhr Seite 16 GB 9. Troubleshooting The following table describes the possible problems which may arise when you use the wood splitter and provides recommended remedial measures for dealing with them. Problem Motor fails to start Probable cause Motor circuit breaker has been triggered Trunk is incorrectly positioned Trunk exceeds permitted dimensions Wedge fails to cut Remedy Allow the motor to cool down and press in the motor circuit breaker switch Position the trunk correctly Reduce the size of the trunk Trunk fails to split Sharpen the wedge. Remove burrs and nicks from the wedge Contact an authorized dealer Contact an authorized dealer Check the oil level. [. . . ]