User manual EINHELL BT-OS

[. . . ] We accept no liability for damage or accidents which arise due to non-observance of these instructions and the safety information. Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes. 4. Technical data Mains voltage: Power input: Orbits: Grinding/sanding area: Abrasive paper size: Protection class: Weight: 230 V~ 50 Hz 150 W 11, 500 rpm 187 x 90 mm 240 x 90 mm II / 1. 5 kg 1. [. . . ] Always wear goggles and a dust mask when carrying out sanding/grinding work. Everybody who uses the machine or enters the workplace must wear a dust mask. Do not eat, drink or smoke at the workplace. Do not use the machine on paints which contain lead. 7. Replacing the power cable If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. 8. Cleaning, maintenance and ordering of spare parts Always pull out the mains power plug before starting any cleaning work. 8. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep into the device. 6. Operation 6. 1 Switching the machine on and off (Fig. 8/Item 2) To switch on: Press the control switch (2). Continuous operation: Lock the control switch by pressing the locking switch (3). To switch off: Press the control switch briefly and release it. 10 Anleitung_BT_OS_150_SPK1:_ 13. 02. 2008 8:55 Uhr Seite 11 GB 8. 2 Carbon brushes In case of excessive sparking, have the carbon brushes checked only by a qualified electrician. The carbon brushes should not be rep laced by anyone but a qualified electrician. 8. 3 Maintenance There are no parts inside the equipment which require additional maintenance. 8. 4 Ordering replacement parts: Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. isc-gmbh. info 9. Disposal and recycling The unit is supplied in packaging to prevent its being damaged in transit. This packaging is raw material and can therefore be reused or can be returned to the raw material system. The unit and its accessories are made of various types of material, such as metal and plastic. [. . . ] In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]