User manual EINHELL BT-PG 850

[. . . ] When using the equipment, a few safety precautions must be observed to avoid injuries and damage. Please read the complete operating instructions and safety regulations with due care. Keep this manual in a safe place, so that the information is available at all times. If you give the equipment to any other person, hand over these operating instructions and safety regulations as well. [. . . ] Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes. Operating mode S1 (continuous operation) The machine can be continuously operated with the quoted power output. Operating mode S2 (temporary operation) The machine may be temporarily operated with the quoted power output. Afterwards the machine must be stopped for a while to prevent it from overheating. Before putting the machine into operation The generator is to be operated only with equipment whose voltage specifications conform with the generator's output voltage. Never connect the generator to the power supply (socket-outlet). Keep the cable length to the consumer as short as possible. 3a) and fit into the recess on the bottom of the tank cover (Figure 3b). Screw the tank cover onto the tank closure. Use the set of screws (9) to fasten the carry handle (2) onto the tank (Fig. 4 Connecting to earth The housing is allowed to be connected to earth in order to discharge static electricity. To do this, connect one end of a cable to the earth connection on the generator (Fig. 4) and the other end to an external earth (for example an earthing rod). 1 Starting the engine Open the petrol cock (8) by turning it down Move the ON/OFF switch (5) to position "ON" with the key. If the engine does not start, pull the handle again. Push the choke lever (4) back again after the engine has started. When starting with the reserve starter, the motor may recoil suddenly as it starts up, resulting in hand injuries. Wear protective gloves when starting the equipment. 2 Connecting consumers to the generator Connect the appliance you want to use to the 230 V~ socket. Important: This socket may be loaded continuously (S1) with 650W and temporarily (S2) for a maximum of 15 minutes with 800W. Do not connect the generator to the household network as this may result in damage to the generator itself or to other electrical appliances in your home. note: Some electrical appliances (power jigsaws , drills , etc. [. . . ] Pull the starter cable several times carefully to wet the internal components with the oil. Store the machine in a cold, dry place where it is out of the reach of ignition sources and inflammable substances. Fertilizers and other chemical garden products often contain substances that accelerate the rate of corrosion of metals. Do not store the machine on or near fertilizers or other chemicals. [. . . ]