User manual EINHELL BT-RH 1500

[. . . ] Anleitung_BT_RH_1500_SPK1:_ 11. 04. 2008 10:57 Uhr Seite 1 Bedienungsanleitung Bohrhammer t p C Operating Instructions Rotary Hammer Mode demploi Marteau perforateur Istruzioni per luso Martello perforatore lL Betjeningsvejledning Borehammer A Használati utasítás Fúrókalapács Bf Upute za uporabu Ceki za busenje 4 j W Uputstva za upotrebu Ceki za busenje Návod k obsluze Vrtací kladivo Návod na obsluhu Vtacie kladivo Art. -Nr. : 42. 584. 45 I. -Nr. : 01017 BT-RH 1500 Anleitung_BT_RH_1500_SPK1:_ 11. 04. 2008 10:58 Uhr Seite 2 Um eine Beschädigung des Gerätes zu vermeiden, soll die Umschaltung zwischen den einzelnen Funktionen nur im Stillstand erfolgen. t p C Select between the individual functions only when the equipment is at a standstill. If you fail to observe this point, the equipment may be damaged. Pour éviter tout endommagement de lappareil, la commutation entre les différentes fonctions doit se faire à larrêt. [. . . ] 5) Pull back and hold the locking sleeve (2) and remove the tool. 6) Slide the dust collection device (a) over the drill bit before carrying out any hammer drilling vertically above your head. 6. To prevent all danger, the machine must only be held using the two handles (6/8). Otherwise there may be a risk of suffering an electric shock if you drill into cables. 1) To switch on: Press the control switch (4). To switch off: Release the control switch (4). 7) The hammer drill has a hammer stop facility for gentle initial drilling. Turn the rotary switch for the hammer stop facility (5) to position (B) to switch off the hammer facility. To switch on the hammer facility again the rotary switch for the hammer stop facility (5) must be turned back to position (A). 8 / 9) The rotation function of the hammer drill can be switched off for chiseling jobs. To do this, press the button (C) on the rotary switch (3) whilst at the same time turning the rotary switch (3) into position A (see Fig. To switch on the rotation facility again, press button (C) on the rotary switch (3) whilst at the same time turning the rotary switch (3) into position B (see Fig. Please note that it is not possible to operate the hammer drill with the hammer stop and rotation stop facilities both active at the same time. Only low pressure is required for hammer drilling. Excessive pressure will exert an unnecessary force on the motor. Check the drill bits at regular intervals. 11 Anleitung_BT_RH_1500_SPK1:_ 11. 04. 2008 10:58 Uhr Seite 12 GB 7. Replacing the power cable If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. 9. Disposal and recycling The unit is supplied in packaging to prevent its being damaged in transit. This packaging is raw material and can therefore be reused or can be returned to the raw material system. The unit and its accessories are made of various types of material, such as metal and plastic. Defective components must be disposed of as special waste. [. . . ] Please note the following terms under which guarantee claims can be made: 1. These guarantee terms cover additional guarantee rights and do not affect your statutory warranty rights. We do not charge you for this guarantee. Our guarantee only covers problems caused by material or manufacturing defects, and it is restricted to the rectification of these defects or replacement of the device. [. . . ]