User manual EINHELL BT-RH 600

[. . . ] Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes. The corresponding safety information can be found in the enclosed booklet. Read all safety regulations and instructions. [. . . ] Select the correct speed: The most suitable speed depends on the workpiece, the type of use and the drill bit used. Low pressure on the ON/OFF switch (4): Lower speed Greater pressure on the ON/OFF switch (4): Higher speed Tip: Start drilling holes at low speed. Benefits: The drill bit is easier to control when starting the hole and will not slide away. You avoid drilling messy holes (for example in tiles). 6/Item 11) The speed setting ring (11) enables you to define the maximum speed. The ON/OFF switch (4) can only be pressed to the defined maximum speed setting. set the speed using the setting ring (11) on the ON/OFF switch (4). Do not attempt to make this setting whilst the drill is in use. Switch the direction of the hammer drill using the clockwise/counter-clockwise switch (9): Direction Clockwise (forwards and drill) Counter-clockwise (reverse) Switch position A B immediately each time you have finished using it. Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep into the device. The carbon brushes should not be rep laced by anyone but a qualified electrician. 3 Maintenance There are no parts inside the equipment which require additional maintenance. 4 Ordering replacement parts: Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. Only low pressure is required for hammer drilling. The unit is supplied in packaging to prevent its being damaged in transit. This packaging is raw material and can therefore be reused or can be returned to the raw material system. The unit and its accessories are made of various types of material, such as metal and plastic. Defective components must be disposed of as special waste. If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. Always pull out the mains power plug before starting any cleaning work. [. . . ] In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]