User manual EINHELL BT-SD 4.8 F

[. . . ] Any other use is deemed to be a case of misuse. The user / operator and not the manufacturer will be liable for any damage or injuries of any kind caused as a result of this. Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes. 1. [. . . ] Only ever use screwdriver bits which are suitable for the purpose and in faultless condition. Always check for concealed electric cables and gas and water pipes when drilling and screwing in walls. 6. Operation 6. 1 Charging the battery (Fig. Check that your mains voltage is the same as that marked on the rating plate of the battery charger. Plug the battery charger in the plug socket and connect the charging cable to the charging connection. The charging process starts as soon as the charging cable is connected to the charging adapter. The red LED (8) will come on to indicate that the battery pack is being charged. It does not switch off automatically when fully charged!Disconnect the charge cable from the screwdriver after charging. The handle may become a little warm during the charging process. If the battery pack fails to charge, please check whether there is voltage at the socket-outlet and check for proper contact with the charging contacts in the battery charger. If the battery still fails to charge, send the battery charger and the screwdriver to our customer services department. Timely recharging of the battery pack will help it serve you well for a long time. You must recharge the battery pack when you notice that the power of the screwdriver drops. 7. Cleaning, maintenance and ordering of spare parts Always pull out the mains power plug before starting any cleaning work. 7. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or solvents; these could attack the plastic parts 9 Anleitung_BT_SD_4_8F_SPK1:_ 13. 09. 2008 10:43 Uhr Seite 10 GB of the equipment. Ensure that no water can seep into the device. 7. 2 Maintenance There are no parts inside the equipment which require additional maintenance. [. . . ] Please note that our devices have not been designed for use in commercial, trade or industrial applications. Consequently, the guarantee is invalidated if the equipment is used in commercial, trade or industrial applications or for other equivalent activities. The following are also excluded from our guarantee: compensation for transport damage, damage caused by failure to comply with the installation/assembly instructions or damage caused by unprofessional installation, failure to comply with the operating instructions (e. g. connection to the wrong mains voltage or current type), misuse or inappropriate use (such as overloading of the device or use of non-approved tools or accessories), failure to comply with the maintenance and safety regulations, ingress of foreign bodies into the device (e. g. [. . . ]