User manual EINHELL BT-SH 90-350

[. . . ] Any errors made in following the safety regulations and instructions may result in an electric shock, fire and/or serious injury. Keep all safety regulations and instructions in a safe place for future use. The saw blade sharpener is designed for sharpening carbide-tipped saw blades with a diameter of 90 350 mm. The equipment is to be used only for its prescribed purpose. [. . . ] Now move the grinding wheel (10) using the handle (7) between the teeth of the saw blade so that when the saw blade is turned clockwise against the grinding wheel (10) the whole surface area of the carbide metal plate on the saw blade lies flat on the grinding wheel (10) (Fig. Do not move the motor so far forwards that the saw blade can be touched by the grinding wheel. Adjust the stop (14) so that the grinding wheel (10) cannot be moved beyond this position into the saw blade and secure it in this position using the Allen screw (L) (Fig. 3 Setting the tooth set angle In addition to the tilt angle of the motor (5), the saw blade set must be adjusted accordingly for set saw blades. For this purpose undo the two nuts (H), tilt the motor (5) until the required angle is shown on the scale (13) and secure it by tightening the two nuts (H) (Fig. 3 Grinding set saw blades To grind saw blades with set teeth, the motor (5) must be titled to the set angle of the saw blade as described in point 6. 2 but in this case every second tooth must be ground according to its set. Then adjust the angle to the set of the teeth you have not yet ground (see point 6. If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. Always pull out the mains power plug before starting any cleaning work. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep into the device. Undo the three screws (M) on the grinding wheel cover (8) and remove it (Fig. Place the pin (C) in the opening (I) and slowly turn the grinding wheel (10) by hand until the pin (C) blocks the equipment's drive shaft (Fig. Clean the flange and fit the new grinding wheel using the above instructions in reverse and secure it. 2 Grinding saw blades Proceed as follows to grind saw blades: Switch on the equipment (see 7. 1) Turn the saw blade so that the grinding wheel (10) is between the saw blade teeth and then move the grinding wheel (10) as far as possible to the front using the handle (7) (Fig. Turn the saw blade slowly and carefully in a clockwise direction into the rotating grinding wheel (10) and grind the carbide metal plates on the saw blade until their cutting edge has been sharpened (Fig. [. . . ] These guarantee terms cover additional guarantee rights and do not affect your statutory warranty rights. We do not charge you for this guarantee. Our guarantee only covers problems caused by material or manufacturing defects, and it is restricted to the rectification of these defects or replacement of the device. Please note that our devices have not been designed for use in commercial, trade or industrial applications. [. . . ]