User manual EINHELL BT-TC 600

[. . . ] If you fail to observe this time limit the motor will overheat. During the OFF period the motor will cool again to its starting temperature. Noise emission values The noise generated by this equipment is measured in accordance with DIN EN ISO 3744; 11/95. the machine may exceed 85 db (A) at the workplace. [. . . ] For optimum performance and maximum safety, keep the machine clean at all times. check the machine cable at regular intervals. While the machine is running, check the wearing parts and the fastenings of parts which may have become loose and check that all accessories are correctly fitted. Check that the water level is high enough to cover the diamond part of the wheel each time before you start a cutting operation and keep checking it during cutting as well. If everything is working properly the control lamp (23) will go out and the contact to the power supply will be interrupted. Press the reset key (22) again in order to be able to start up the machine. 2) To replace the wheel when worn, proceed as follows: Pull out the power plug first. Unscrew the lock nut (18) on the wheel flange (16) with a 19 mm wrench. Clean the wheel flange thoroughly once the wheel has been removed. Take out the worn diamond cutting wheel (15) and fit the new one to the flange, then fit the outer flange (16) and tighten with the nut (18). 3/6) Insert the splitter (19) through the table and into the holder (11) from above and fasten with the screws (20). Move the wheel guard to approximately 5 mm above the tile you wish to cut. Lock the wheel guard (3) in position with the knurled screw (9) as shown in Fig. The machine is fitted with a cutting wheel with a non-segmented edge. Keep a constant check on the water level 7. 5 and lock in position with the handles (7). Position the tile with the glazed side on the work surface and make sure that the diamond wheel does not touch the glaze on the tile. 5 shows the correct position for your hands during miter cutting to 45°. The right hand holds the workpiece in contact with the diamond wheel while the left hand pushes the workpiece forward. the rate of advance must not exceed the cutting capacity of the wheel. This is to make sure that no material comes off, as this may cause accidents or injuries. Always pull out the mains power plug before starting any cleaning work. [. . . ] Connection to the wrong mains voltage or current type), misuse or inappropriate use (such as overloading of the device or use of non-approved tools or accessories), failure to comply with the maintenance and safety regulations, ingress of foreign bodies into the device (e. Damage caused by the device being dropped) and normal wear resulting from proper operation of the device. The guarantee is rendered null and void if any attempt is made to tamper with the device. The guarantee is valid for a period of 2 years starting from the purchase date of the device. [. . . ]