User manual EINHELL DTA 25-2

[. . . ] this is important to avoid the hazards of free-flying staples and of overloading the appliance. For the purposes of transportation, the stapler must be disconnected from the compressed-air system, especially if you are using a ladder or are adopting an unusual posture. In the workplace, carry the stapler only by its handle and ensure that the trigger is inactivated. make allowance for the workplace conditions. [. . . ] If a staple/nail becomes stuck in the piston shaft, first disconnect the stapler and make sure it is not under any pressure before you remove the cover plate. With the magazine open and the rest of the staples/nails removed you can then take out the jammed staple. Clean the shaft if necessary and close again. Observance of the following maintenance instructions will ensure that this quality tool gives you years of troublefree service. Before starting to work, always check that the magazine is secure. Clean the tool thoroughly when you are finished with your work. regular lubrication is vital for the long-term , reliable operation of your stapler. Use only special tool oil for this purpose. You can choose from the following options for lubricating the tool: 6. 1 By mist oiler A complete conditioning unit includes a mist oiler and is fitted to the compressor. 2 By hand If your air system has neither a conditioning unit nor a line oiler, you must feed 3-5 drops of special tool oil into the air connection each time before you use your stapler. If the pneumatic tool has not been used for several days, you must feed 5-10 drops of oil into the air connection before you switch on. Keep your pneumatic tool in dry rooms only. Screw the supplied plug-in nipple into the air connection. To fill the magazine, press on the magazine lever and pull back the lower magazine shaft as far as the stop. Insert the staples/nails into the magazine rail from above. Do not insert more than one complete stick of staples/nails or the magazine will be too full and can no longer be Wearing parts Damage caused by an unacceptable level of working pressure. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. [. . . ] In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. Please keep your sales receipt in a safe place, as it is your proof of purchase. It would help us if you could describe the nature of the problem in as much detail as possible. [. . . ]