User manual EINHELL EBH 750

[. . . ] The power cable must have a cross-section of 3 x 1. Some of the causes for this are: - Cracking due to old age of the insulation - Kinking caused by improper fastening or guidance of the power cable Even though power cables with damaged insulation sheaths pose a lethal hazard, some people still use them. Cables, plugs and socket couplers must meet the following requirements listed below. Power cables used to connect machines must have a rubber insulation sheath. [. . . ] 12/Item 1) and secure the power cable with the strain-relief clamp (Fig 12/Item 2). 13/Item 2) which must be pressed before the lever switch (Fig. Repeat this process several times so that you are sure that your machine functions properly. Before you perform any repair or maintenance work on the machine, ensure that the hoe blades are not rotating and that the power supply is disconnected. Always ensure that a safe distance (provided by the long handles) is maintained between the machine and the user. Be especially careful when changing direction on slopes and inclines. maintain a solid footing and wear sturdy , non-slip footwear and long trousers. Always scarify along the incline (not up and down). Use special caution when backing up and pulling the machine (tripping hazard). Maintenance and cleaning work on the machine as well as removal of the safety devices may only be performed when the motor is switched off and the power cable has been pulled. Worn out or damaged hoe blades should only be replaced by an authorized professional (see address on warranty certificate). Do not clean the tool with running water - and particularly not with a pressure hose. ) are always tightened so that the machine can be safely operated at all times. All the metal parts should be cleaned and then oil to ensure that they provide a long life. For best results, clean the plastic parts of the machine with a brush or rag. At the end of the season, perform a general inspection of the machine and remove any deposits which may have accumulated. Place the machine in front of the area you wish to hoe and hold it securely on the push bar before you switch on the machine. To achieve cleanly hoed soil always ensure that you guide the machine in straight lines wherever possible. Insodoing, the aeration swaths should always overlap each other by a few centimeters in order to avoid bare strips. Switch off the motor promptly when you arrive at the 12 Season, ensure that you check the condition of the machine. If repairs are necessary, please contact one of our customer service centers (see address on warranty certificate). Voltage Power input Working width Hoe diameter Idle speed Number of blades LPA noise level LWA peak noise level Vibration at the handlebars ahv 230V ~ 50Hz 750 W 30 cm 22 cm 400 rpm 4 pieces 70 dB(A) 93 dB(A) 2. [. . . ] In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]