User manual EINHELL KSGZ300-1

[. . . ] Even when the machine is used as prescribed it is still impossible to eliminate certain residual risk factors. The following hazards may arise in connection with the machine's construction and design: Contact with the saw blade in the uncovered saw zone. Reaching into the running saw blade (cut injuries). Catapulting of faulty carbide tips from the saw blade. [. . . ] Never saw several workpieces simultaneously. Never remove loose splinters, chips or jammed pieces of wood when the saw blade is running. To rectify faults or remove jammed pieces of wood, always switch off the machine first. Conversions, adjustments, measurements and cleaning jobs are to be performed only when the motor is switched off. before you switch on the machine , check that all wrenches and adjustment tools have been removed. When you leave your workplace, switch off the motor and pull out the power plug. Electric installation work, repairs and maintenance are to be carried out only by specialists. All guards and safety devices have to be refitted immediately after completion of any repairs or maintenance. It is imperative to observe the manufacturer's safety, operating and maintenance instructions as well as the dimensions quoted in the technical data. It is imperative to observe the accident prevention regulations in force in your area as well as all other generally recognized rules of safety. note the information published by your professional associations. (VBG7j) Switch on the dust extraction system each time you use the machine. The machine may be used in closed rooms only in conjunction with a suitable vacuum extraction system. The circular cross-cut must be connected to a 230 V socket-outlet with a minimum 10 A fuse. never use light-duty machines for heavy-duty work. Never use the cable for any purpose other than that for which it is intended!Adopt a firm standing position and keep your balance at all times. Before you carry on using the tool it is imperative to check that its safety devices and any slightly damaged parts are working properly and in the way intended. Check that the moving parts work properly and do not jam or whether any of the parts are damaged. Unless otherwise stated in these instructions, damaged safety devices and parts must be repaired or replaced by experts in an approved specialist workshop. have damaged switches replaced by a customer service workshop. This tool complies with the pertinent safety regulations. [. . . ] Using the handle (2), push downward all the way through the work-piece with uniform and light pressure. After the cutting process is finished, bring the machine head back to its upper (home) position and release the ON/OFF button (3). Do not simply let go of the handle (2) after cutting, but allow the machine head to slowly lift up by applying slight counterpressure. 4/5) Lower the machine head (4) and fasten in place with the safety pin (16). [. . . ]