User manual EINHELL MBF 550

[. . . ] Work on electrical equipment may only be carried out by a qualified electrician!Routing head Compound table Machine column Work spindle Gear lever Speed selector switch Wheel selector for fine feed ON/OFF switch Ring gear drill chuck Hand crank for cross slide Hand crank for saddle slide Depth stop Fixing nut for angle adjustment Star handle Spindle guard Hinged chip guard The same applies for the general rules of health and safety at work. The manufacturer will not be liable for any changes made to the machine nor for any damage resulting from such changes. Even when the machine is used as prescribed it is still impossible to eliminate certain residual risk factors. [. . . ] Before you connect the machine to the power supply, make sure the data on the rating plate is the same as that for your mains. Important: The machine must be screwed tight to the base using four screws. To do this, use the four fixing holes in the baseplate of the machine. Make sure that there is enough space for the compound table to traverse and for angle adjustments. You must also make sure that what is underneath the machine is sufficiently stable to support the weight (approx. All bare parts of the machine are already greased in order to protect them from corrosion. Clean the machine with a suitable environmentally friendly cleaning agent before using it for the first time. Do not use any cleaning agents that could attack the paintwork of the machine and ensure sufficient ventilation during cleaning. Lubricate the machine with non-acidic lubricating oil again after cleaning. Important: Oil, grease and cleaning agents are harmful to the environment and must be disposed of in an environmentally compatible way - not with household rubbish!3 Mains connection / switch The machine may only be operated with singlephase current 230 Volt / 50 Hz. The electric circuit of the house must be protected by no more than a 16A fuse. 3) The hinged chip guard (16) must be in the "down" position before the machine is switched on. to switch on , press the green button (I). If the green indicator light (a) illuminates, the machine can be switched on using the speed selector switch (6) and the desired rotational speed can be set. If the orange indicator light (b) also illuminates, the speed selector switch (6) must be put into the "0" position and the yellow light will go off again. The desired rotational speed of the machine can then be set and the machine will start up. 2 Switching off the machine Switch the machine off by pressing the red "O" button or the "EMERGENCY OFF" button (c) and then unplug the power plug. Important: Always unplug the power plug before making any adjustments to the machine. 1 Setting the rotational speed Use the gear lever (5) on the machine side to choose between two speed ranges. Front position (L) for the rotational speed rang 50 to 1100 min-1 Rear position (H) for the rotational speed range 120 to 2500 min-1 Important: Do not change rotational speed ranges (L and H) while the spindle is running!The rotational speed can be adjusted infinitely within the speed range. [. . . ] For added protection, identical routing cutters are best kept in a box when not in use. To prevent further damage and injury, please contact our Customer Services department if any faults occur which require more than the normal maintenance. The address is given in the warranty card. Check that the routing head can move easily and make sure that it has not worked loose. [. . . ]