User manual EINHELL RG-CT 14

[. . . ] The machine is to be used only for its prescribed purpose. Any other use is deemed to be a case of misuse. The user / operator and not the manufacturer will be liable for any damage or injuries of any kind caused as a result of this. Please note that our equipment has not been designed for use in commercial, trade or industrial applications. [. . . ] The line will be cut to the correct length when the cutting head starts up again. A short or worn nylon line produces poor cutting results. Your grass trimmer will work at its best if you observe the following instructions: Never use the grass trimmer without its safety devices. To switch on your grass trimmer, press the safety lock-off and the ON/OFF switch (Fig. Do not move the grass trimmer against the grass until the switch is pressed, i. For the correct cutting action, swing the grass trimmer to the side as you walk forward, holding it at an angle of approx. 30° as you do so (see Figure 19-20). Make several passes to cut long grass shorter step by step from the top (see Figure 21). Make full use of the guide hood in order to avoid unnecessary line wear. Keep the grass trimmer away from hard objects in order to avoid unnecessary line wear. The line will be cut to the correct length when the cutting head starts up again. Catapulted pieces of nylon line may cause injury!3 Maintenance There are no parts inside the equipment which require additional maintenance. 4 Ordering replacement parts: Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. Switch off and unplug the grass trimmer before putting it away or cleaning it. 1 Cleaning Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible. Wipe the equipment with a clean cloth or blow it with compressed air at low pressure. We recommend that you clean the device immediately each time you have finished using it. Clean the equipment regularly with a moist cloth and some soft soap. Do not use cleaning agents or solvents; these could attack the plastic parts of the equipment. Ensure that no water can seep into the device. Remove deposits from the guard hood with a brush. [. . . ] In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]