User manual EINHELL RG-PS 5

[. . . ] Vor Inbetriebnahme Bedienungsanleitung und Sicherheitshinweise lesen und beachten Read and follow the operating instructions and safety information before using for the first time. Scope of use Safety information Layout Items supplied Installation Spray quantities Preparing pesticides for use Filling Spraying Technical data Cleaning Checking the dosage Maintenance Cleaning/replacing the pump diaphragm Ordering spare parts Waste disposal Read the operating instructions before use. Hold the spray lance and do not direct the jet at other people. Do not expose tanks filled with spray solution to temperatures below zero. [. . . ] Ensure that you note the stop point while doing this (Fig. Important: Check to ensure that the screw connections for the hose at the spray gun handle and on the tank are tight!Note: Always follow the manufacturers instructions when mixing spray solutions. Fill the tank only with the amount of solution you intend to use. 0 liters per tree Older, free-standing trees 3. Pump/carry handle Nozzle Swan-neck Spray tube Spray tube holder Spray gun handle Release lever Carrying strap Pressure gauge Spray funnel Overpressure valve Pesticides must be used outdoors only and never in living quarters, stables, or storage rooms for food and animal feed. Fill a separate container with pesticide and thoroughly premix. If you intend to use organic spray solutions, they must be filtered prior to filling the sprayer. Before you screw out the pump, raise the overpressure valve (Figure 1/Item 11) and let off any overpressure that may be in the unit. Press down the pump/carry handle as far it will go and slowly unscrew the pump (counterclockwise). fill the tank up to the 5 liter mark (max. ) with the solution mixed in accordance with the chemical manufacturers instructions. Insert the pump, press down the pump/carry handle as far it will go and screw in the pump (clockwise) until it is tight again. Whenever you transport the pressure sprayer. Also, the spray tube should be in the holder provided for the purpose (Fig. 60° Nozzle recoil force less than 5 N Net weight 2. 35 l/min Note: The residual quantity refers to the liquid that remains in the sprayer when the nozzle starts to leak air. Release the pump/carry handle from the bayonet lock by pressing it down and gently turning it counterclockwise. Pressure is built up in the tank by pumping the pump/carry handle (up and down). note: The pumping process can be facilitated by removing the spray funnel (Fig. 1/Item 10) from the storage compartment (bootstrap) and holding the pressure sprayer on the ground with your foot. The tank pressure can be read off the pressure gauge at any time (Fig. [. . . ] Prior to performing any maintenance work on the unit, always relieve the pressure via the overpressure valve (Fig. 1/Item 11) by raising the overpressure valve. Ensure that you observe the safety instructions. The service life of the unit will be increased dramatically if you regularly clean the diaphragm (Fig. [. . . ]