User manual EINHELL RG-SP 750 LL

[. . . ] In stagnant water bodies, garden ponds, swimming ponds and their surrounding areas the unit may only be used with an earth-leakage circuit breaker with an actuating rated current of up to 30 mA (according to VDE 0100 Part 702 and 738). The equipment is not designed for use in swimming pools and paddling pools of any kind or other bodies of water in which people or animals may be present during operation. This equipment is not designed to be used by people (including children) with limited physical, sensory or mental capacities or those with no experience and/or knowledge unless they are supervised by a person who is responsible for their safety or they have received instructions from such a person in how to use the equipment safely. Children must always be supervised in order to ensure that they do not play with the equipment. [. . . ] This bridges the integrated floating switch so that the equipment runs continuously. Water can be pumped down to 4 mm in manual mode. Please note: The depth of water must be at least 15 mm before the equipment can be run in manual mode!Before putting the equipment into operation 2) Secure the carry handle (1) with the fastening nut (3) (Fig. 2 Installation The equipment can be installed either: Stationary with rigid tubing or Stationary with a flexible hose line Note!When installing, never hang the equipment by the discharge line or by the power cable. The equipment must be hung up with the provided carry handle or it must rest on the bottom of the shaft. To ensure that the equipment works properly, the bottom of the shaft always must be free of sludge and other accumulations of dirt. If the water level is too low, the sludge in the shaft can quickly dry out and hinder the equipment from starting. It is necessary therefore to check the equipment regularly (carry out trial startups). Note: The pump shaft should measure at least 10 If the power cable for this equipment is damaged, it must be replaced by the manufacturer or its aftersales service or similarly trained personnel to avoid danger. The unit is supplied in packaging to prevent its being damaged in transit. This packaging is raw material and can therefore be reused or can be returned to the raw material system. The unit and its accessories are made of various types of material, such as metal and plastic. Defective components must be disposed of as special waste. Unplug the power plug prior to any maintenance work. For mobile applications, the equipment should be cleaned with clear water after every usage. For stationary installation, it is recommended that you check the floating switch for proper functioning every three months. Use a water jet to remove any lint or fibrous particles that may have become trapped in the housing. Remove sludge from the shaft bottom and clean the shaft walls every 3 months. Use clear water to remove deposits from the floating switch. 1 Cleaning the paddle wheel If a lot of deposits collect in the housing, the bottom part of the equipment must be dismantled as follows: 1. [. . . ] In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]