User manual EINHELL RT-ID 75

[. . . ] The corresponding safety information can be found in the enclosed booklet. Read all safety regulations and instructions. Any errors made in following the safety regulations and instructions may result in an electric shock, fire and/or serious injury. Keep all safety regulations and instructions in a safe place for future use. [. . . ] set the depth stop (2) to the same level as the drill bit. Pull the depth stop back by the required drilling depth. Turn the handle on the additional handle (8) until it is secure. Now drill the hole until the depth stop (2) touches the workpiece. 11/Item 5) First fit a suitable drill bit into the tool (see 5. It may only be locked if the drill is set to rotate clockwise. 11/Item 5) You can infinitely vary the speed whilst using the tool. Select the speed by applying a greater or lesser pressure to the ON/OFF switch (5). Select the correct speed: The most suitable speed depends on the workpiece, the type of use and the drill bit used. Low pressure on the ON/OFF switch (5): Lower speed (suitable for: small screws and soft materials) Greater pressure on the ON/OFF switch (5): Higher speed (suitable for large/long screws and hard materials) Tip: Start drilling holes at low speed. Benefits: The drill bit is easier to control when starting the hole and will not slide away. You avoid drilling messy holes (for example in tiles). 11/Item 6) The speed setting ring (6) enables you to define the maximum speed. The ON/OFF switch (5) can only be pressed to the defined maximum speed setting. set the speed using the setting ring (6) on the ON/OFF switch (5). Do not attempt to make this setting whilst the drill is in use. Switch the direction of the hammer drill using the clockwise/counter-clockwise switch (7): Direction Switch position Clockwise (forwards and drill) Pushed in to the right Counter-clockwise (reverse) Pushed in to the left 6 Drilling with the dust extraction system (9) Use the dust extraction system only for drilling into concrete, bricks and masonry since wood or plastic chips may block the extraction system. Do not drill into metallic materials since hot metal chips can damage the dust extraction system. Harmful dust must not be extracted using the dust extraction system (9). Tip: To prevent the wall being soiled, you can mask the area around the transparent extraction opening with masking tape. Before you use the masking tape, test whether the tape can be removed easily from the wall again in a place that it not easily visible. Switch on the vacuum cleaner and place the transparent cover on the front of the dust extraction system (9) over the drilling point so that the drill bit is in front of the mark. [. . . ] In the unlikely event that your device develops a fault, please contact our service department at the address shown on this guarantee card. Of course, if you would prefer to call us then we are also happy to offer our assistance under the service number printed below. Please note the following terms under which guarantee claims can be made: 1. These guarantee terms cover additional guarantee rights and do not affect your statutory warranty rights. [. . . ]