User manual EINHELL RT-PG 2500

[. . . ] When using the equipment, a few safety precautions must be observed to avoid injuries and damage. Please read the complete operating instructions and safety regulations with due care. Keep this manual in a safe place, so that the information is available at all times. If you give the equipment to any other person, hand over these operating instructions and safety regulations as well. [. . . ] Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses or for equivalent purposes. Operating mode S1 (continuous operation) The machine can be continuously operated with the quoted power output. Operating mode S2 (temporary operation) The machine may be temporarily operated with the quoted power output. Afterwards the machine must be stopped for a while to prevent it from overheating. Before putting the machine into operation The generator is to be operated only with equipment whose voltage specifications conform with the generator's output voltage. Never connect the generator to the power supply (socket-outlet). Keep the cable length to the consumer as short as possible. 3 Connecting to earth The housing is allowed to be connected to earth in order to discharge static electricity. To do this, connect one end of a cable to the earth connection on the generator (Fig. 3/4) and the other end to an external earth (for example an earthing rod). Important: These sockets may be loaded continuously (S1) with 2000W and temporarily (S2) for a maximum of 5 minutes with 2200W. the generator is suitable for 230 V~ AC appliances. Do not connect the generator to the domestic power network as this may result in damage to the generator itself or to other electrical appliances in your home. note: Some electrical appliances (power jigsaws , drills , etc. ) may have a higher level of power consumption when used in difficult conditions. 3 Switching off the engine Before you switch off the generator, allow it to run briefly with no consumers so that it can "cool down" Move the ON/OFF switch (10) to position "OFF" with the key. If this happens, reduce the electric power you are taking from the generator or remove any defective connected appliances. Defective overload cut-outs must be replaced only by overload cut-outs of identical design and with the same performance data. If repairs are necessary, please contact your customer service center. You must fill up with engine oil (approx. Check the fuel level and top it up if necessary Make sure that the generator has sufficient ventilation Make sure that the ignition cable is secured to the spark plug Inspect the immediate vicinity of the generator Disconnect any electrical equipment which may already be connected to the generator 6. [. . . ] 5 Automatic oil cut-out The automatic oil cut-out responds if there is too little oil in the engine. In this case it will not be possible to start the engine or it will cut out automatically after a short period of time. It cannot be started again until the engine oil has been topped up (see point 7. 6 Ordering replacement parts: Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. [. . . ]