User manual EINHELL RT-TC 430 U

[. . . ] No other use is permitted and the manufacturer will not accept liability for any damages or injury resulting from any such use; responsibility rests with the user/operator in any such case. Only use cutting wheels which are suitable for the machine. Compliance with the safety instructions, the assembly instructions, and advice and instructions on operation contained in the operating instructions also falls under the terms of intended use. All persons operating or carrying out maintenance work on the machine must be acquainted with the above and be aware of all potential dangers. [. . . ] All covers and safety devices must be correctly attached before the machine is used for the first time. the cutting wheel must rotate smoothly. Check that the voltage on the rating plate is the same as your supply voltage before you connect the machine to the power supply. If everything is working properly the control lamp (43) will go out and the contact to the power supply will be interrupted. Press the reset key (42) again in order to be able to start up the machine. 14-15) Undo the screws (28) and push the angle stop (5) into the required position. Move the machine head (29) to the far end with the handle (9). Move the machine head (29) slowly and smoothly forward through the tile with the handle (9). Switch off the tile cutting machine after completion of cutting. Clean the mounting flange thoroughly before fitting the new cutting wheel. Fit the new cutting wheel by following the above procedures in reverse and then tighten. Then fit the two trough mounts (f) as shown in Figure 7. The pump, cable and cooling water hose (14) must not be able to get into the cutting area. Fill with water until the pump (13) is completely immersed in water. Important: Before you lift the equipment out of the trough or transport it, the cutting unit must be secured again with the star handle screw (11) and spacer (40). Before you begin cutting, wait until the cutting wheel has reached maximum speed and the cooling water pump (13) has started supplying the cutting wheel with water. Clean off all dust and soiling from the machine at regular intervals, preferably with a cloth or a brush. lubricate all moving parts at regular intervals. Do not use any aggressive cleaning agents to clean plastic parts. Clean off any soiling on the trough (3) and cooling agent pump (13) at regular intervals, otherwise the diamond cutting wheel (2) may not be cooled as required. Please quote the following data when ordering replacement parts: Type of machine Article number of the machine Identification number of the machine Replacement part number of the part required For our latest prices and information please go to www. The unit is supplied in packaging to prevent its being damaged in transit. [. . . ] In such cases, the work performed or parts fitted will not result in an extension of the guarantee period, and no new guarantee will become active for the work performed or parts fitted. This also applies when an on-site service is used. In order to assert your guarantee claim, please send your defective device postage-free to the address shown below. Please enclose either the original or a copy of your sales receipt or another dated proof of purchase. [. . . ]