User manual EINHELL SB 501-1

[. . . ] Machine base Pillar Fixing screw Drill table Clamping screw Machine head V-belt Motor Grip knobs Scroll chuck Spindle Mounting holes Hinged chip guard Depth stop (only SB 401/1) Tightening screw Screw Clamping screw (only SB 501/1) On switch Off switch Grub screw the rating plate. Use a socket-outlet with earthing contact The device may only be operated from an outlet with the properly installed earthing contact. Extension cable The cord cross section of an extension cable must measure at least 1. Protection against electrical shock Keep the device away from moisture. [. . . ] B Fasten the mounting flange with pillar (2) to machine base (1) using three screws (3) and washers. B Push the drill table (4) with drill table clamp shaft onto the pillar (2) (Fig. B Lock the drill table into the desired position using the clamping screw (5). B Place the drill head (6) with V-belt cover (7) and motor (8) onto the drill pillar and fasten using the grub screw (20). B Screw the three ball-shaped handles (9) onto the feeder cross handle. Note: All bare parts are greased in order to protect them from corrosion. Before mounting the drill chuck (10) onto the spindle (11), both parts must be completely degreased using an environmentally friendly solvent. 1/2) Before the drill is started for the first time, it must be solidly and fully mounted on the work area of a stable workbench. Note: The fixing screws may only be tightened to a point where they do not distort or deform the base plate. 5 Unscrew the three recessed head screws (21). Push the transparent cover (23) into the groove of the red mounting frame (24) and fasten it again with the recessed head screws (21). The height of the cover (23) is infinitely adjustable and can be locked using the two thumb screws (22). The chip guard (13) can be flipped upwards to change drill bits; ensure, however, that the chip guard (13) is back in its initial position before restarting the machine. Prior to starting Ensure that the voltage of the mains supply complies with the specifications on the rating plate. Connect the machine only to a socket with the properly installed earthing contact. 14 The table drill is equipped with a no-volt trip that is designed to protect the operator from an undesired restart following a drop in voltage. Should this occur, the machine must be manually restarted. Rugged and tight-fitting) when working with the table drill. Long hair should always be bound back with a hair net or a cap!3) To switch on the machine, push in the green On button , , I" (18); the machine starts up. to switch off , press the red Off button , , O" (19); the device shuts down. Ensure that you do not overload the device. [. . . ] When setting the drill depth of a cylindrical hole you must add the length of the drill tip 7. Only adjust the setting when the machine is at a standstill. -Lower the drilling spindle (11) until the tip of the drill bit touches the workpiece. -Slacken the clamping screw (17) and turn the scale ring (25) forwards until it stops. [. . . ]