User manual EIZO FLEXSCAN L351

[. . . ] ENGLISH SAFETY SYMBOLS This manual uses the safety symbols below. Please read them carefully. WARNING Failure to abide by the information in a WARNING may result in serious injury and can be life threatening. CAUTION Failure to abide by the information in a CAUTION may result in moderate injury and/or property or product damage. Indicates a prohibited action. Indicates to ground for safety. Copyright© 2000 by EIZO NANAO CORPORATION. No part of this manual may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, or otherwise, without the prior written permission of Eizo Nanao Corporation. [. . . ] · Leaving the ScreenManager idle for 45 seconds or more will turn the adjustment off automatically, without saving the adjustments. 14 3. ScreenManager Adjustments and Settings. The following table shows all the ScreenManager's adjustment and setting menus. Main menu Screen Sub menu Position Resolution Smoothing Brightness DVI DMPM Off timer Menu Position Reference ENGLISH 4-1. Screen Adjustment (p. 17) PowerManager Others Information Language 4-2. Power-save Setup (p. 19) Set the monitor's timer to on or off (p. 16). Adjust the ScreenManager's menu position. Reset Return to the factory default settings. 25) Information Review the current ScreenManager's settings. English, German, French, Select the ScreenManager's language. Spanish, Italian, Swedish and Japanese 3-3. Useful Functions Adjustment Lock Use the "Adjustment Lock" function to prevent any accidental changes. Locked function Unlocked function · Adjustments and settings in the ScreenManager. · Brightness selection button · Adjustment of brightness by the up and down buttons. · To lock Press on the brightness selection button while switching on the power. · To unlock Switch off the monitor's power, then hold down the brightness selection button once again and turn the power back on. 3. ScreenManager 15 Off Timer The off timer function causes the monitor to automatically enter a power off state after a predetermined amount of time has lapsed. This function was created to reduce afterimage p. 27) characteristics that are particular to LCD monitors when the monitor screen is left on for a long period without use. [Procedure] (1) Select "Off Timer" in the ScreenManager "Others" menu. (2) Select "Enable" and press the right and left buttons to adjust the "On Period" (1 to 23 hours). [Off timer system] PC On Period (1H~23H) Last 15 min. in "On period" "On period" expired *1 Monitor Operation Advance Notice *1 "Power Off" Mode LED Green Green Flashing Flashing yellow slowly Advance notice (LED flashing green) will be given 15 minutes before the monitor automatically enters the "Power Off" mode. To delay entering the "Power Off" mode, press any button during the advance notice period. The monitor will continue to operate for an additional 90 minutes. Press any button to return to a normal screen. · The off timer function works while the PowerManager is active, but there is no advance notice before the monitor's power is switched off. 16 3. [. . . ] Lead** Lead can be found in picture tubes, display screens, solders and capacitors. Lead damages the nervous system and in higher doses, causes lead poisoning. The relevant TCO'99 requirement permits the inclusion of lead since no replacement has yet been developed. * Bio-accumulative is defined as substances which accumulate within living organisms. ** Lead, Cadmium and Mercury are heavy metals which are Bio-accumulative. For U. S. A, Canada, etc. [. . . ]