User manual EIZO FLEXSCAN L461

[. . . ] ENGLISH ENGLISH SAFETY SYMBOLS This manual uses the safety symbols below. Please read them carefully. WARNING Failure to abide by the information in a WARNING may result in serious injury and can be life threatening. CAUTION Failure to abide by the information in a CAUTION may result in moderate injury and/or property or product damage. Indicates a prohibited action. Indicates to ground for safety. Copyright© 2001 by EIZO NANAO CORPORATION. No part of this manual may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, or otherwise, without the prior written permission of Eizo Nanao Corporation. [. . . ] Use the "Position" adjustment. The correct displayed position of LCD monitor is decided because the number and the position of the pixels are fixed. The "Position" adjustment moves the image to the correct position. Select "Position" and adjust the position so all the dotted line appear around screen, by using the up, down, right and left buttons. (4) Screen image is smaller or larger than the actual screen images. Use the "Resolution" adjustment. Adjustment is needed when the input signal resolution and the resolution now being displayed is different. Select "Resolution" and confirm if the resolution now being displayed is the same as the input resolution. If it is not, adjust the vertical resolution using the up and down button and adjust the horizontal resolution using the right and left buttons. Smaller than the actual screen images. Adjusted to actual screen Larger than the actual screen images. 20 4. ADJUSTMENT 4. To set the Output signal range (Dynamic Range) of the signal. Use the "Range Adjustment". p. 36) This controls the level of output signal range to display the whole color gradation (256 colors). Select the "Range Adjustment" in the "ColorManagement" menu. [Auto] Push the Auto adjustment button on the front panel while displaying the "Range adjustment" menu to automatically adjust the range. The screen blanks for a moment, and adjusts the color range to display the whole color gradation of the current output signal. · Pressing Auto adjustment button while displaying the contrast/brightness adjustment screen (appeared by pressing the control buttons directly) adjusts the range automatically. ENGLISH 5. To set the Contrast of the screen. Use the "Contrast" adjustment. This controls the brightness for the each color (red, blue and green) at a same time. Select "Contrast/Brightness" in the screen menu and adjust by using the right and left buttons. 6. To set the Brightness of the screen. Use the "Brightness" adjustment. This controls the brightness for the entire screen. The brightness of the entire screen is controlled by changing the brightness if the backlight. Select "Contrast/Brightness" in the screen menu and adjust by using the up and down buttons. · Directly pressing the control buttons also adjusts the contrast and brightness. Press the "Enter" button to save and exit the settings after the adjustment. 4. Displaying the low resolutions The lower resolutions are enlarged to full screen automatically. Using the "ScreenSize" function in the "Others" menu enables to change the screen size. 1. To enlarge the screen size when displaying a low resolution. Select "Screen Size" Select the "Screen Size" in the others menu and select the screen size by using the up and down buttons. · Full Displays the picture on the screen in full, irrespective of the picture's resolution. [. . . ] CFCs (freons) The relevant TCO'99 requirement states that neither CFCs nor HCFCs may be used during the manufacture and assembly of the product. CFCs (freons) are sometimes used for washing printed circuit boards. CFCs break down ozone and thereby damage the ozone layer in the stratosphere, causing increased reception on earth of ultraviolet light with e. g. increased risks of skin cancer (malignant melanoma) as a consequence. [. . . ]