User manual EIZO FLEXSCAN L565

[. . . ] User's Manual Color LCD Monitor English SAFETY SYMBOLS This manual uses the safety symbols below. Please read them carefully. WARNING Failure to abide by the information in a WARNING may result in serious injury and can be life threatening. CAUTION Failure to abide by the information in a CAUTION may result in moderate injury and/or property or product damage. Indicates a prohibited action. Indicates to ground for safety. Copyright© 2002 by EIZO NANAO CORPORATION. No part of this manual may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, or otherwise, without the prior written permission of Eizo Nanao Corporation. [. . . ] Use the <Range Adjustment> (p. 35)of <ColorManagerment> menu. This controls the level of output signal range to display the whole color gradation (256 colors). [Procedure 1] Push the Auto adjustment button on the front panel while displaying the <Range Adjustment> menu to automatically adjust the range. The screen blanks for a moment, and adjusts the color range to display the whole color gradation of the current output signal. [Procedure 2] Pressing Auto adjustment button while displaying the contrast/brightness adjustment screen (appeared by pressing the control buttons directly) adjusts the range automatically. (Contrast and Brightness will not be adjusted. ) 5. To smooth the blurred texts of the enlarged screen of the lower resolutions. Switch the <Smoothing> setting. Select the suitable level from 1 ­ 5 (Soft ­ Sharp). Select <Smoothing> in the <Screen> menu and adjust by using the right and left buttons. NOTE · The "Smoothing" is disabled in the resolution 1280 x 1024. · Since the displayed image is enlarged, the blurred texts may not be necessarily lost completely. 22 4. ADJUSTMENT English 6. To set the Contrast of the screen. Use the <Contrast> adjustment. This controls the brightness for the each color (red, blue and green) at the same time. Select <Contrast/Brightness> and adjust by using the right and left buttons. NOTE · Percentage except 100 % may cause undisplayable color tone. · During selecting the <sRGB> of <ColorManagement>, contrast cannot be adjusted. 7. To Set the Brightness of the screen. Use the <Contrast> adjustment. The brightness of the entire screen is controlled by changing the brightness of the backlight. Select <Contrast/Brightness> in the screen menu and adjust by using the up and down buttons. NOTE · Directly pressing the up and down buttons also adjusts the contrast and brightness. Press the "Enter" button to save and exit the settings after the adjustment. 4. Color Adjustment The <ColorManagement> menu in the ScreenManager enables to change the color of the screen. By using the <Color Mode>, the adjustment mode can be selected from <Custom mode> (to adjust the color settings according to your preference) and <sRGB> mode. In the analog input, perform the "Range Adjustment" (p. 22) before making the color adjustments. NOTE · Allow the LCD monitor to stabilize for at least 20 minutes before making image adjustments. (Allow the monitor to warm up for at least 20 minutes before making adjustments. ) · Performing the <Reset> of the <ColorManagement> menu returns the color settings to the default settings (Except <Range Adjustment> settings). [. . . ] increased risks of skin cancer (malignant melanoma) as a consequence. Lead** Lead can be found in picture tubes, display screens, solders and capacitors. Lead damages the nervous system and in higher doses, causes lead poisoning. The relevant TCO'99 requirement permits the inclusion of lead since no replacement has yet been developed. * Bio-accumulative is defined as substances which accumulate within living organisms. [. . . ]