User manual EIZO FLEXSCAN L675

[. . . ] ENGLISH ENGLISH ® SAFETY SYMBOLS This manual uses the safety symbols below. Please read them carefully. WARNING Failure to abide by the information in a WARNING may result in serious injury and can be life threatening. CAUTION Failure to abide by the information in a CAUTION may result in moderate injury and/or property or product damage. Indicates a prohibited action. Indicates to ground for safety. Copyright© 2000 by EIZO NANAO CORPORATION. No part of this manual may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, or otherwise, without the prior written permission of Eizo Nanao Corporation. [. . . ] ADJUSTMENT 27 2. Smooth the blurred texts of the enlarged screen. Use the "Smoothing" adjustment. Select the suitable level from 1 ~ 5 (Soft ~ Sharp). Select "Smoothing" in the screen menu and adjust by using the right and left buttons. · "Smoothing" is disabled when the screen is displayed in the following resolution. * 1280 x 1024 * The image size is doubled both in horizontally and vertically (i. e. 1280 x 960 enlarged from 640 x 480) to provide clear focus which does not require this function. 3. Set the brightness of the black area surrounding the displayed image. Set the "Border Intensity" In the "Enlarged" mode or "Full Screen" mode, the outer area (border) is usually black. Select "Border Intensity" in the others menu and adjust by using the right and left buttons. Border 28 4. Color Adjustment The "ColorManagement"menu in the ScreenManager enables to change the color of the screen. ENGLISH Before the Color adjustment · Allow the LCD monitor to stabilize for at least 20 minutes before making color adjustments. · After finishing each adjustment in the custom mode, select "Save" icon to resister the adjustment. · The adjustment values represent the current level within the specific adjustment only. They are available only as a reference tool. (To create a uniform white or black screen, the percentages for each will probably not be the same. ) · In the analog input, perform the "Range Adjustment" (p. 25) before making the color adjustments . The gradation pattern like below is recommended for the "Range Adjustment". 1. To change the color tone of the white. Set the "Temperature". p. 46) The "Temperature" can be set from 4, 000 K to 10, 000 K , in 500 K increments (including 9, 300 K). To resister the adjustment in the custom mode, select the "Save" icon and then push the enter button. · Setting the temperature under 4, 000 K or over 10, 000 K invalidates the color temperature setting. (The color temperature's setting turns "OFF". ) · Adjusting the "Gain" (p. 30) invalidates the color temperature setting. (The color temperature's setting turns "OFF". ) 4. ADJUSTMENT 29 2. To change the saturation. Use the "Saturation" adjustment. The "Saturation" can be selected from -16 to 16. Setting the minimum level (-16) turns the image to the monochrome. To register the adjustment, select the "Save" icon and then push the enter button. · The "Saturation" adjustment may cause undisplayable color tone. 3. To change the flesh color, etc. [. . . ] CFCs (freons) The relevant TCO'99 requirement states that neither CFCs nor HCFCs may be used during the manufacture and assembly of the product. CFCs (freons) are sometimes used for washing printed circuit boards. CFCs break down ozone and thereby damage the ozone layer in the stratosphere, causing increased reception on earth of ultraviolet light with e. g. increased risks of skin cancer (malignant melanoma) as a consequence. [. . . ]