User manual EIZO FLEXSCAN L685

[. . . ] User's Manual Color LCD Monitor English SAFETY SYMBOLS This manual uses the safety symbols below. Please read them carefully. WARNING Failure to abide by the information in a WARNING may result in serious injury and can be life threatening. CAUTION Failure to abide by the information in a CAUTION may result in moderate injury and/or property or product damage. Indicates a prohibited action. Indicates to ground for safety. Copyright© 2001 by EIZO NANAO CORPORATION. No part of this manual may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, or otherwise, without the prior written permission of Eizo Nanao Corporation. [. . . ] Using the <Screen Size> function in the <Others> menu enables to change the screen size. 1. Enlarge the screen size when displaying a low resolution. Select the <Screen Size>. Select the <Screen Size> in the others menu and select the screen size by using the up and down buttons. Menu Full Function Displays the picture on the screen in full, irrespective of the picture's resolution. Since the vertical resolution and the horizontal resolution are enlarged at different rates, some images may appear distorted. Displays the picture on the screen in full, irrespective of the picture's resolution. Since the vertical resolution and horizontal resolution are enlarged at same rates, some horizontal or vertical image may disappear. Displays the picture at the actual Screen resolution. Enlarged Normal Example: Displaying1024 x 768 Full Enlarged Normal (1280×1024) (1280×960) (1024×768) 2. Smooth the blurred texts of the enlarged screen. Switch the <Smoothing> setting. Select the suitable level from 1 ­ 5 (Soft ­ Sharp). Select <Smoothing> in the <Screen> menu and adjust by using the right and left buttons. NOTE · <Smoothing> is disabled when the screen is displayed in the following resolutions. *1280 x 1024 *The image size is doubled both in horizontally and vertically to (i. e. 1280 x 960 enlarged from 640 x 480) provide clear focus which does not require this function. 26 4. ADJUSTMENT English 3. Set the brightness of the black area surrounding the displayed image. Set the <Border Intensity>. In the <Enlarge> mode or <Full Screen> mode, the outer area (border) is usually black. Select <Border Intensity> in the <Others> menu and adjust by using the right and left buttons. Border 4. Color Adjustment The <ColorManagement> menu in the ScreenManager enables to change the color of the screen. By using the <Color Mode>, the adjustment mode can be selected from <Custom mode> (to adjust the color settings according to your preference) and <sRGB> mode. In the analog input, perform the "Range Adjustment" (p. 24) before making the color adjustments. NOTE · Allow the LCD monitor to stabilize for at least 20 minutes before making image adjustments. (Allow the monitor to warm up for at least 20 minutes before making adjustments. ) · Performing the <Reset> of the <ColorManagement> menu returns the color settings to the default settings. (Except <Range Adjustment> settings). · The values shown in percentages represent the current level within the specific adjustment. They are available only as a reference tool. [. . . ] increased risks of skin cancer (malignant melanoma) as a consequence. Lead** Lead can be found in picture tubes, display screens, solders and capacitors. Lead damages the nervous system and in higher doses, causes lead poisoning. The relevant TCO'99 requirement permits the inclusion of lead since no replacement has yet been developed. * Bio-accumulative is defined as substances which accumulate within living organisms. [. . . ]