User manual EIZO FLEXSCAN L771

[. . . ] ENGLISH SAFETY SYMBOLS This manual uses the safety symbols below. Please read them carefully. WARNING Failure to abide by the information in a WARNING may result in serious injury and can be life threatening. CAUTION Failure to abide by the information in a CAUTION may result in moderate injury and/or property or product damage. Indicates a prohibited action. Indicates to ground for safety. Copyright© 2000 by EIZO NANAO CORPORATION. No part of this manual may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, or otherwise, without the prior written permission of Eizo Nanao Corporation. [. . . ] 1600 x 1200 enlarged from 800 x600) to provide clear focus which does not require this function. 3. Set the brightness of the black area surrounding the displayed image. Set the "Border Intensity" In the "Enlarged" mode or "Full Screen" mode, the outer area (border) is usually black. Select "Border Intensity" in the others menu and adjust by using the right and left buttons. Border 4. Color Adjustment The "ColorManagement"menu in the ScreenManager enables to change the color of the screen. Before the Color adjustment · Allow the LCD monitor to stabilize for at least 20 minutes before making color adjustments. · After finishing each adjustment in the custom mode, select "Save" icon to resister the adjustment. · The values shown in percentages represent the current level within the specific adjustment only. They are available only as a reference tool. (To create a uniform white or black screen, the percentages for each will probably not be the same. ) · Perform the "Range Adjustment" before making the color adjustments. The gradation pattern like below is recommended at the "Range Adjustment". 1. To change the color tone of the white. Set the "Temperature"p. 42) The temperature can be set from 4, 000 K to 10, 000 K , in 500 K increments (except 9, 300 K). To resister the adjustment in the custom mode, select the "Save" icon and then push the enter button. · The values shown in the Kelvin are available only as a reference tool. · Setting the temperature under 4, 000 K or over 10, 000 K invalidates the color temperature setting. (The color temperature's setting turns "OFF". ) · Adjusting the "Gain" (p. 27) invalidates the color temperature setting. (The color temperature's setting turns "OFF". ) 26 4. ADJUSTMENT 2. To change the saturation. Adjust the "Saturation" The saturation can be selected from -16 ~ 16. Setting the minimum level (-16) turns the image to the monochrome. To register the adjustment, select the "Save" icon and then push the enter button. ENGLISH · The "Saturation" adjustment may cause undisplayable color tone. 3. To change the flesh color, etc. Adjust the "Hue" The "Hue" can be selected from -20 ~ 20. To register the adjustment, select the "Save" icon and then push the enter button. · The "Hue" adjustment may cause undisplayable color tone. 4. To adjust each color (red, green and blue). Adjust the "Gain"p. 42) By adjusting the red, green and blue color tones for each mode, custom colors can be defined. [. . . ] Lead damages the nervous system and in higher doses, causes lead poisoning. The relevant TCO'99 requirement permits the inclusion of lead since no replacement has yet been developed. * Bio-accumulative is defined as substances which accumulate within living organisms. ** Lead, Cadmium and Mercury are heavy metals which are Bio-accumulative. For U. S. A, Canada, etc. (rated 100-120 Vac) Only FCC Declaration of Conformity We, the Responsible Party EIZO NANAO TECHNOLOGIES INC. [. . . ]