User manual EIZO FLEXSCAN T566

[. . . ] User's Manual FlexScan T566 Color Display Monitor Important , Please read this User's Manual carefully to familiarize yourself with safe and effective usage procedures. Please retain this manual for future reference. English SAFETY SYMBOLS This manual uses the safety symbols below. Please read them carefully. WARNING Failure to abide by the information in a WARNING may result in serious injury and can be life threatening. CAUTION Failure to abide by the information in a CAUTION may result in moderate injury and/or property or product damage. Indicates a prohibited action. Indicates to ground for safety. Copyright© 2002 by EIZO NANAO CORPORATION. [. . . ] [To unlock] Switch off the monitor's power, then hold down the AUTO/FINE MODE button once again and turn the power back on. 3. SCREEN ADJUSTMENT 19 English 3-6. Connecting two PCs to the Monitor Two PCs can be connected to the monitor through the BNC/D-Sub input connections on the rear of the monitor. (Example) Standard graphics board MD-C53A (Optional) Power Macintosh G3 (Blue&White) /G4 Selecting the Active input Every time the BNC/D-Sub selection button is pressed, the input changes in order. [Automatically selecting the priority input signal for screen] The monitor will automatically detect the input signal of either the BNC or D-Sub connection for display. In the following cases, the signal given preference will be displayed automatically. · Once a priority is selected in the <Input Priority> function, whenever a change of signal is detected at the selected input, the monitor will switch the input to that signal. [How to give priority to the input] (1) Select <Input Priority> in the <Others> menu. (2) Select <Auto> and set BNC or D-Sub input. Saving the adjustment data The adjustment data can be saved for both signals. However, the following adjustment and setting data can be saved for each input signal (BNC/D-Sub). <Contrast>, <Fine Contrast>, <Temperature>, <Custom> and <sRGB> 20 3. TROUBLESHOOTING If a problem persists even after applying the suggested remedies, contact an EIZO dealer. *The bracket < > indicates the function of ScreenManager Problems 1. No picture · Indicator status: Off Points to check with possible solutions Check that the power cord is correctly connected. If the problem persists, turn off the monitor power for a few minutes, then turn it back on and try again. Try pressing a key on the keyboard, or clicking the mouse. 18) Try pressing the AUTO/FINE MODE button or control pad or turn the monitor off and then on. 19) These messages appear when the signal is not input correctly, even if the monitor functions properly. When the image is displayed correctly after a short time, it is not a monitor's problem. (Some PCs do not output the signal soon after powering on). Check that the signal cable is properly connected to the PC or graphics board. Switch the signal input by pressing the BNC/D-Sub selection button on the front control panel. [. . . ] Lead** Lead can be found in picture tubes, display screens, solders and capacitors. Lead damages the nervous system and in higher doses, causes lead poisoning. The relevant TCO'99 requirement permits the inclusion of lead since no replacement has yet been developed. * Bio-accumulative is defined as substances which accumulate within living organisms. ** Lead, Cadmium and Mercury are heavy metals which are Bio-accumulative. For U. S. A, Canada, etc. [. . . ]