User manual EIZO FLEXSCAN T765

[. . . ] SAFETY SYMBOLS This manual uses the safety symbols below. Please read them carefully. WARNING Failure to abide by the information in a WARNING may result in serious injury and can be life threatening. CAUTION Failure to abide by the information in a CAUTION may result in moderate injury and/or property or product damage. Indicates a prohibited action. Indicates to ground for safety. Copyright© 2001 by EIZO NANAO CORPORATION. No part of this manual may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic, mechanical, or otherwise, without the prior written permission of Eizo Nanao Corporation. [. . . ] · Even if the monitor is in a power saving mode, the devices connected to the monitor's USB ports (both the upstream and the downstream) will function. Connecting to the USB HUB (Setting up the USB function) · Do not connect the downstream port of the monitor to any peripherals until finishing the USB function. · The followings are procedures for the Windows 98/Me/2000 and Mac OS. 1. 2. Connect the monitor to the PC with the signal cable (See page 10) first, then turn on the PC. Connect the upstream port of the monitor to the downstream port of the USB compliant PC or another hub by using the USB cable . Upstream port: Connect the USB compliant PC or another hub using the USB cable. 4. MAKING USE OF USB (Universal Serial Bus) 19 3. After setting up, the monitor's USB hub is available for connecting USB compliant peripherals to the downstream ports of the monitor. (Connection example) Scanner USB Cable Printer Monitor Digital Camera PC Keyboard Mouse <Front port> <Rear port> Downstream connector Downstream ports: Connect the cables from USB compliant peripherals such as a mouse, keyboard, etc. ScreenManager Pro for USB (for Windows) For further details about the "ScreenManager Pro for USB", refer to the readme. txt in the CD-ROM. 20 4. MAKING USE OF USB (Universal Serial Bus) 5. TROUBLESHOOTING If a problem persists even after applying the suggested remedies, contact an EIZO dealer. *The bracket < > indicates the function of ScreenManager Problems 1. No picture · Indicator status: Off Points to check with possible solutions Check that the power cord is correctly connected. If the problem persists, turn off the monitor power for a few minutes, then turn it back on and try again. Try pressing a key on the keyboard, or clicking the mouse. 17) Try pressing the AUTO/FINE MODE button or control pad or turning the monitor off and then on. 17) These messages appear when the signal is not inputted correctly, even if the monitor functions properly. Error messages will remain on the screen for 30 seconds. When the image is displayed correctly after a short time, it is not a monitor's problem. (Some PCs do not output the signal soon after powering on). Check that the signal cable is properly connected to the PC and graphics card. Switch the signal input by pressing the BNC/D-Sub selection button on the front control panel. Use the graphics board's utility software to change the frequency setting. (Refer to the manual of the graphics board). ENGLISH · Indicator status: Green · Indicator status: Flashing Green / Yellow · Indicator status: Flashing Yellow 2. ·"No signal detected" error message appears. ·"Out of range" error message appears. [. . . ] Lead damages the nervous system and in higher doses, causes lead poisoning. The relevant TCO'99 requirement permits the inclusion of lead since no replacement has yet been developed. * Bio-accumulative is defined as substances which accumulate within living organisms. ** Lead, Cadmium and Mercury are heavy metals which are Bio-accumulative. For U. S. A, Canada, etc. (rated 100-120 Vac) Only FCC Declaration of Conformity We, the Responsible Party EIZO NANAO TECHNOLOGIES INC. [. . . ]