User manual ELECTRO-VOICE 100S DATASHEET

[. . . ] A polarized plug has two blades with one wider than the other. A grounding type plug has two blades and a third grounding prong. The wide blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult an electrician for replacement of the obsolete outlet. [. . . ] This window allow the user to adjust the contrast preferences of the LCD screen and the brightness of the front panel buttons to compensate for different lighting conditions that may be encountered within different venues. Use the VALUE up/down buttons to choose between: -10 to +10 LCD contrast. This window displays the firmware version currently running on the Dx46. This window displays the IP address and network mask of the Dx46. Use the VALUE up/down buttons to edit the IP address of the Dx46. Following table shows the default values of the ethernet interface. This window shows the on-time and the unique MAC addresss of the Dx46. Use the VALUE up/down buttons to choose your editing preferences. The Link, Id and Mask parameters (see following table) are used for linking parameters of Dx46 devices connected via Ethernet. use the < SELECT > buttons to navigate to the Link , Id and Mask parameters. Use the VALUE up/ down buttons to edit the corresponding value. Users can set their VU metering preferences here. Use the VALUE up/down buttons to choose between Normal Fast, Peak Hold and Slow Decay. use the < SELECT > buttons to navigate to the VU Reference parameter. Use the VALUE up/down buttons to choose between D/A Clip and Limiter Threshold. A lockout mode has been provided for the installer to protect the system settings from being modified by a user. This can be set from the front panel or from the GUI software. Following table shows the different protection levels of the Dx46. Mode GUI-Settable Panel and USB Locked Panel Locked Unlocked Description One or more parameters of the Dx46 are locked via IRIS-Net and are not visible and/or editable via the front panel. The buttons on the Dx46 front panel are locked. The buttons on the Dx46 front panel are locked. All parameters can be configured via the Dx46 front panel or IRIS-Net. [. . . ] OUT 1 is the left Low-frequency output and OUT 2 is the left Highfrequency output. This configuration represents a 3-way frequency crossover where IN A serves as the left input channel and IN B as the right input channel. OUTs 1 & 4 L/R are the Sub frequency channel, OUT 2 & 5 L/R are Low and Mid-frequency channels, 3 & 6 L/R are the Highfrequency channels. Crossover channels are fed from IN A, full range channels are from IN B. [. . . ]