User manual ELECTRO-VOICE 602F DATASHEET

[. . . ] . 12 Bodypack Transmitter Setup and Operation . . 14 Bodypack Transmitter Setup and Operation . . 15 Section 4 - Receiver Display Screens and Functions . . 24 Section 5 - Transmitter Screens and Detail Functions . [. . . ] See the accessories section at the end of this manual for optional antennas. Pinch the battery door tabs inward and pull the door open. Insert a 9V battery as indicated by +/- in the holder. (Note: the 602F-BP unique design allows the battery to be inserted and used regardless of the positive and negative terminal position, the indicators are there for reference only). Turning the transmitter On - With battery compartment still open, turn the unit on with Power switch on the top panel. The battery low LED and display back light will light for a second and the display will show the battery level, the Group and Channel numbers. Press SET, the Group number will flash and can be changed with the UP/DOWN keys. Once the desired Group number is showing, press SET to select and the Channel number will flash. Select the Channel and press SET again, the flashing will stop and the channel is now set. Press SET and DOWN at the same time to display the exact transmit frequency. Press SET and DOWN at the same time to display the battery level in percent. To engage power lock press and hold SET, UP and DOWN at the same time until ON-LOCK appears in the display. To turn the unit off while in ON-LOCK, place the power switch in the OFF position and push any one of the SET, UP or DOWN buttons. To remove the lock, press and hold SET, UP and DOWN again at the same time until ON-OFF appears in the display. The ON-LOCK mode can also be entered by quickly cycling the power switch three times. But using this method the unit will not be in ON-LOCK the next time it is powered up. Change Lock-Out - Disables the SET button to protect settings. To engage Change Lock press and hold the UP and DOWN arrow keys together until SECURE appears in the display. To remove the Change Lock, press and hold the UP and DOWN keys until ACCESS appears in the display. With the transmitter and receiver on and matching Group and Channel, the main receiver display should be indicating an RF signal on the bar graph. Speak into the microphone and the Audio Meter bar graph should indicate audio signal presence. If the level meters do not show reception, make certain the group and channel are matching and refer to the trouble shooting section. [. . . ] Approvals: All models are in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. See below for other Declaration of Conformity information. Licensing: Licensing of all models is the users responsibility. Licensing is different from country to country. [. . . ]