User manual ELECTRO-VOICE 951 DATASHEET

[. . . ] Power Handling Test Electro-Voice components and systems are manufactured to exacting standards to en- sure reliability in continuous use in arduous real-life conditions. Besides utilizing industry-standard power tests, extreme in-house power tests which push the performance boundaries of the loudspeakers are also performed for an extra measure of reliability. The Xi-1082 systems are rated per ANSI/ EIA RS-426-A Loudspeaker Power Rating, Full Range Test, which uses a shaped-random-noise signal to simulate typical music to test the mechanical and thermal capabilities of the loudspeakers. Specifically, the Xi-1082 passes the ANSI/EIA RS-426-A power test with the following test parameters: PE(MAX): 175 watts Test Voltages: 34. 2 volts rms 68. 3 volts peak 6. 67 ohms RSR(1. 15 RE): Suspending the Xi-1082 The Xi-1082 is fitted with several threaded inserts and can be suspended as follows: 1. [. . . ] Two 3/8-16 threaded inserts are located on each side of the enclosure to allow the use of the Mb1082 mounting bracket. The Mb1082 is a universal U-bracket de signed to allow the suspension of the Xi1082 at any angle and orientation from X-Array InstallTM Xi-1082 Loudspeaker System the wall or ceiling. Full instructions are included with the Mb1082. Four 5/16-18 threaded inserts are located in the rear panel to allow use of the OmniMount Series 100 support system. Full instructions can be obtained from: OmniMount Systems, Inc. Tempe, AZ 85281 Tel: 602/829-8000 Fax: 602/756-900. WARNING: It is the responsibility of the installer to ensure that the mounting surface has sufficient rigidity to support the Xi-1082 and that the mounting bracket is correctly fitted to the surface and to the Xi-1082. Suspending an object is potentially dangerous and should only be attempted by individuals who have a thorough knowledge of the techniques and regulations of rigging objects overhead. It is the responsibility of the installer to ensure the Xi-1082 is safely installed in accordance with applicable regulations. If the Xi-1082 is suspended, Electro-Voice strongly recommends that the system be inspected at least once a year. Electro-Voice shall not be liable for any incidental or consequential damages including, without limitation, injury to persons or property or loss of use. Some states do not allow the exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you. Other Rights: This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. Electro-Voice Speakers and Speaker Systems are guaranteed against malfunction due to defects in materials or workmanship for a period of five (5) years from the date of original purchase. The Limited Warranty does not apply to burned voice coils or malfunctions such as cone and/or coil damage resulting from improperly designed enclosures. Electro-Voice active electronics associated with the speaker systems are guaranteed for three (3) years from the date of original purchase. Additional details are included in the Uniform Limited Warranty statement. Electro-Voice Accessories are guaranteed against malfunction due to defects in materials or workmanship for a period of one (1) year from the date of original purchase. Additional details are included in the Uniform Limited Warranty statement. Electro-Voice Flying Hardware (including enclosure-mounted hardware and rigging accessories) is guaranteed against malfunction due to defects in materials or workmanship for a period of one (1) year from the date of original purchase. [. . . ] Electro-Voice Flying Hardware (including enclosure-mounted hardware and rigging accessories) is guaranteed against malfunction due to defects in materials or workmanship for a period of one (1) year from the date of original purchase. Additional details are included in the Uniform Limited Warranty statement. For warranty repair, service information, or a listing of the repair facilities nearest you, contact the service repair department at: 616/695-6831 or 800/685-2606. For technical assistance, call: 800/234-6831. [. . . ]