User manual ELECTRO-VOICE CO10R

[. . . ] The rigid tube prevents unsightly twisting of the gooseneck but permits the user to exactly position the microphone. The electronics module is terminated with a male XLR-type 3-pin connector that allows the microphone to be plugged directly into an existing panel-mount XLR receptacle. The electronics module can also be surface mounted using the included mounting clips. The housing is machined brass for ruggedness and superior EMI/RFI attenuation. [. . . ] The PC-12/FL and PC-18/FL are designed to be phantom-powered with a wide voltage range of 12-52V dc (DIN Standard 45 596). PolarChoice Series PC-12/FL and PC-18/FL Microphones Applications: The PC-12/FL and PC-18/FL can be used on lecterns, podiums, desk and tabletops, or other applications that require a threaded or flange mounted gooseneck microphone. To maximize gain-before-feedback the PolarChoices three directional polar patterns allow the user to pick the directional polar pattern for optimum effect. For those applications where gainbefore-feedback is not a problem, an omnidirectional pattern is included. Applications requiring speaking close to the microphone at podiums, lecterns, or pulpits normally require a windscreen to control breath noise and P-popping or, in some cases, wind noise from circulating air. Technical Specifications: Generation Element: Dual condenser, back electret Frequency Response: 50 Hz to 20, 000 Hz (see chart) Polar Patterns: (see chart) Omnidirectional Cardioid Supercardioid Hypercardioid Sensitivity, Open Circuit Voltage, 1 kHz: 5. 6mV/Pascal Clipping Level (1% THD): >135 dB SPL Equivalent Noise: <26 dB SPL A weighted (0 dB=20 micropascals) Dynamic Range: >109 dB Output Impedance, 1 kHz: 200 ohms Power Requirements: Phantom, 12 52 VDC Current Consumption: < 8 mA with P12 supply Polarity: Pin 2 positive, referenced to pin 3, with positive pressure on the diaphragm Dimensions Gooseneck Length: PC-12/FL: 313. 2 mm (12. 3 in. ) PC-18/FL: 457. 7 mm (18. 0 in. ) Maximum Head Diameter: 14. 6 mm (0. 58 in. ) Gooseneck Diameter: Lower section, 7. 9 mm (0. 31 In. ) Upper section, 6. 4 mm (0. 25 In. ) Electronics Module Diameter: 20 mm (0. 79 in. ) Connector Diameter: 19 mm (0. 75 in. ) Accessories Furnished: Windscreen Two-piece shock mount, with shock mount adaptor Mounting clips for electronics module Optional Accessories: FMK flange-mount kit CPSM shock-mount kit Color: Nonreflecting black Environmental Conditions, Relative Humidity 0-50%: -29° to 74°C (-20° to 165°F) Relative Humidity 0 to 95%: -29° to 57°C (-20° to 135°F) Net Weight: PC-12/FL: 111 grams (3. 9 oz), 252 grams (8. 9 oz) with electronics module PC-18/FL: 119 grams (4. 2 oz), 261 grams (9. 2 oz) with electronics module Dimension Drawings: Engineering Data Sheet EV Multi-Port Windscreen: All PolarChoice microphones come with the exclusive EV Multi-Port Windscreen. This unique one-piece ported design offers greatly improved resistance to P-popping noise by creating a two-stage filter that has an air space between the stages. This makes the multi-port windscreen as effective as much larger traditional designs. Shock Mount Installation: Drill a 1-3/8 inch hole to mount the hard plastic flange into the desk, table, or lectern top. The type of screws used to fasten the flange will depend on the desktop material. First route the cable, as desired, either out the side of the mic, or through the bottom. Screw the included shock mount adaptor into the bottom of the microphone. Gently push the flexible shock mount onto the adaptor. The microphone will include an external windscreen. The microphone shall have a nonreflecting black finish. The Electro-Voice PolarChoice series PC-12/FL or PC-18/FL is specified. Warranty (Limited) Electro-Voice products are guaranteed against malfunction due to defects in materials or workmanship for a specified period, as noted in the individual productline statement(s) below, or in the individual product data sheet or owners manual, beginning with the date of original purchase. If such malfunction occurs during the specified period, the product will be repaired or replaced (at our option) without charge. The product will be returned to the customer prepaid. Exclusions and Limitations: The Limited Warranty does not apply to: (a) exterior finish or appearance; (b) certain specific items described in the individual product-line statement(s) below, or in the individual product data sheet or owners manual; (c) malfunction resulting from use or operation of the product other than as specified in the product data sheet or owners manual; (d) malfunction resulting from misuse or abuse of the product; or (e) malfunction occurring at any time after repairs have been made to the product by anyone other than Electro-Voice Service or any of its authorized service representatives. Electro-Voice Wired Microphones are guaranteed against malfunction from any cause for three (3) years from the date of original purchase. Any and all active electronics incorporated in these microphones are guaranteed against malfunction due to defects in materials or workmanship for a period of three (3) years from the date of original purchase. The Limited Warranty does not extend to cables, cable connectors, or switches. [. . . ] Any and all active electronics incorporated in these microphones are guaranteed against malfunction due to defects in materials or workmanship for a period of three (3) years from the date of original purchase. The Limited Warranty does not extend to cables, cable connectors, or switches. Obtaining Warranty Service: To obtain warranty service, a customer must deliver the product, prepaid, to Electro-Voice Service or any of its authorized service representatives together with proof of purchase of the product in the form of a bill of sale or receipted invoice. For warranty repair or service information, contact the Service Repair department at: 800/392-3497. [. . . ]