User manual ELECTRO-VOICE CPSM EDS

[. . . ] Mounting a CP212 or CP218 to a podium, lectern or desk top is quick and easy using the CPSM shock-mount kit. The CPSM kit consists of a shock mount, template, set screw, hex-key wrench and three screws. [. . . ] Mount the kit's set screw on the provided hex-key wrench. Insert the set screw into the tapped hole in the steel sleeve and tighten, securing the microphone in the shock mount. Connect the female 3-pin connector to the microphone. If depth is restricted, a rightangle audio connector may be required. Place the shock mount into the drilled hole. Align the shock mount with the three drilled holes. Secure the assembly to the panel by screwing in the three remaining wood screws. Architects'and Engineers' Specifications The shock mount shall have a minimum of 15 dB of shock isolation at a frequency of 200 Hz in the vertical axis. Dimensions shall be 2. 06 inches (52. 32 mm) diameter and 1. 29 inches (32. 77 mm) high. Net weight shall be 1. 21 ounces (34. 35 grams). The shock mount shall have a nonreflecting black polycarbonate plastic outer flange that fits into a hole of 13/8 inches (39. 4 mm) in diameter and is secured to a desk top by three screws; two butyl rubber shock mounts; and a nickel-plated steel inner sleeve that captures the microphone and acts as a theft-resistant security device. The Electro-Voice CPSM shock mount is specified. Limited Warranty Electro-Voice products are guaranteed against malfunction due to defects in materials or workmanship for a specified period, as noted in the individual product-line statement(s) below, or in the individual product data sheet or owner's manual, beginning with the date of original purchase. [. . . ] For warranty repair or service information, contact the service repair department at: 616/695-6831 or 800/685-2606. For technical assistance, contact Technical Support at 800/234-6831 or 616/695-6831, M-F, 8:00 a. m. [. . . ]