User manual ELECTRO-VOICE DH2012 DATASHEET

[. . . ] With the wiring and connector on the transformer pointing to the LEFT, align the mounting holes in the transformer mounting feet with the holes in the baffle board. On each of the 10-24 machine screws provided in the kit, place a lock washer, then a flat washer. [. . . ] Apply a drop of thread locking compound to the threads near the end of each screw. Insert the screws into the mounting holes and tighten securely, taking care not to cross-thread the T-nuts. Feel underneath the left side of the circuit board on the back of the input panel and locate the two input wires with a flat connector in the middle. (If connectors are not present, see Special Instructions below. ) Carefully withdraw the connector and unplug the two halves from each other. Unplug the short pigtails from the Voltage Selector wiring harness. These are only required on early production units which did not have connectors preinstalled. Solder the GREEN wire from the Green/Black pigtail in its place. Do the same with the remaining BLACK wire. Reinstall the Input Panel in the enclosure. Resume installation of the kit at step 9. 4. ) 5. ) 6. ) 7. ) 8. ) 9. ) 10. ) 11. ) 12. ) 13. ) 14. ) 5. ) 6. ) 12000 Portland Avenue South, Burnsville, MN 55337 Phone:952/884-4051, Fax:952/884-0043 www. electrovoice. com © Telex Communications, Inc. 9/2003 Part Number 38110-228 Rev A U. S. A. For customer orders, contact Customer Service at: 800/392-3497 Fax: 800/955-6831 Europe, Africa, and Middle East only. [. . . ] 9/2003 Part Number 38110-228 Rev A U. S. A. For customer orders, contact Customer Service at: 800/392-3497 Fax: 800/955-6831 Europe, Africa, and Middle East only. [. . . ]