User manual ELECTRO-VOICE PHOENIX USER INSTRUC

[. . . ] It is the responsibility of the installer to ensure that all speakers are safely installed in accordance with all such regulations. If Phoenix speakers are suspended, Electro-Voice® strongly recommends that the system be inspected at least once a year. [. . . ] Do not attempt to suspend more than one speaker on a stand designed for a single speaker. Unless you are confident that you can safely handle lifting the weight of the speaker onto the stand, ask another person to help you place it. Route cables and position the stand so that performers, production crew and audience members will not trip over the stand or cables and pull the speaker system over. Secure the cables with wire ties or tape whenever possible. Moisture: Electro-Voice® does not recommend using Phoenix loudspeakers in the rain or in high moisture environments without protection. Hearing Exposure: Electro-Voice® Phoenix loudspeakers are capable of producing sound pressure levels sufficient to produce permanent hearing damage. Caution should be taken to avoid prolonged exposure to sound pressure levels exceeding 90 dB. Processor Settings: Processor settings for Phoenix loudspeaker configurations are available for Electro-Voice® speaker processors. Please consult the Application Guide at www. electrovoice. com for more information. Rotating the Horn: The PX2122 and PX2152 loudspeakers have horns that can be rotated to change the coverage pattern. The coverage pattern angles are molded on the horn flange. Remove the (6) screws that attach the grille to the enclosure (Figure 2). Remove the (12) screws that attach the horn to the enclosure, and disconnect the wires that attach the ND2 to the input panel (Figure 3). The jumper that is between both ND2's can remain connected. Remove the (4) nuts and bolts that connect the manifold to the horn. Rotate the horn 90° so the desired vertical coverage pattern is parallel to the ND2's and manifold, then reattach the manifold using the (4) nuts and bolts (Figure 4). [. . . ] (50mm) Diaphragm Compression Drivers TBA N/A 1219mm x 569mm x 758mm (48. 00" x 22. 42" x 29. 85") 88. 5 kg (195 lbs) 90. 7 kg (200 lbs) Polyester Powder Coated, 16GA Galvanized Steel, with Rotatable Logo TBA TBA TBA PX-D2 Dolly Kit Half Space measurement. 12000 Portland Avenue South, Burnsville, MN 55337 Phone: 952/884-4051, Fax: 952/884-0043 www. electrovoice. com © Telex Communications, Inc. 6/2006 Part Number 38110-533 Rev 2 U. S. A. [. . . ]