User manual ELECTRO-VOICE POLARCHOICE FLANGE EDS

[. . . ] They can be mounted on any fixture that has a standard 5/8" X 27 microphone thread (such as a microphone stand), or they can be mounted to any flat surface using the included threaded flange. Additionally, they can be mounted using the included shock mount and adapter. The cable can be easily changed to exit from either the side, or through the bottom of the microphone. [. . . ] Simply cut the cable to the desired length, and remove sufficient insulation from the wires to allow the conductors to be inserted into the terminal strip in the electronics module. Connect the wires to the module as shown in the wiring guide on this page. For best results, the conductors should first be tinned with solder. Changing the Cable from Side Exit to Bottom Exit: Disconnect the cable from the electronics module Unscrew the hex retainer from the bottom of the gooseneck. Thread the cable through the knurled ring and hex retainer. Screw the hex retainer back on the bottom of the goose neck and tighten securely. 5) Reconnect the cable to the electronics module, according to the wiring diagram. 1) 2) 3) 4) Frequency Response: Polars: Architectural & Engineering Specs: PolarChoice Series PC-12/FL, PC-18/FL The microphone shall be a back-electret condenser type with a frequency response of 50 Hz to 20 kHz. The microphone shall have a nominal, balanced output impedance of 200 ohms. The microphone shall have four selectable polar patterns: omnidirectional, cardioid, supercardioid, and hypercardioid. The microphone shall have an output level of 5. 6 mV/Pascal, and outputs shall not be appreciably affected by the following temperature and humidity extremes: -29° to 74° C (20° to 165°F) when the relative humidity is 0-50%; -29° to 57°C (-20° to 135°F) when the relative humidity is 0-95%. Dimensions shall be 350. 7 mm (13. 8 in. ) long (PC-12/FL), and 495. 1 mm 19. 5 in. ) long, (PC-18/FL) with a maximum head diameter of 14. 6 mm (0. 58 in). The PC-12/FL microphone shall include a 313. 2 mm (12. 3 in. ) gooseneck. The PC-18/FL microphone shall include a 457. 7 mm (18. 0 in. ) gooseneck. The PC-12/FL and PC-18/FL goosenecks microphones will include an external electronics module, which is terminated with a professional XLR-type 3-pin style connector. [. . . ] Electro Voice shall not be liable for any incidental or consequential damages including, without limitation, injury to persons or property or loss of use. Some states do not allow the exclusion or limitation of incidental or consequential damages so the above limitation or exclusion may not apply to you. Other Rights: This warranty gives you specific legal rights, and you may also have other rights, which vary from state to state. [. . . ]