User manual ELECTRO-VOICE POLARCHOICE+ EDS

[. . . ] Non-reflecting black finish. Push-Button on top, where it belongs!Flush Mount XLR Mount General Description: The PolarChoice PC-Plus is the first miniature gooseneck microphone to combine the features and functionality of a desktop mic, with the small unobtrusive size of an XLR mounted gooseneck microphone. The unique profile of the PC-Plus housing places the push button switch and status LED in a more natural position and also creates a lower profile housing. [. . . ] This makes the multi-port windscreen as effective as much larger traditional designs. Dimension Drawings: Engineering Data Sheet Surface Mounting the PC Plus Microphone: Frequency Response: Polars: Architectural & Engineering Specs: PolarChoice PC Plus-12, PC Plus-18 The microphone shall be a back-electret condenser type with a frequency response of 50 Hz to 20 kHz. The microphone shall have a nominal, balanced output impedance of 200 ohms. The microphone shall have four selectable polar patterns: omnidirectional, cardioid, supercardioid, and hypercardioid. The microphone shall have an output level of 5. 6 mV/Pascal, and outputs shall not be appreciably affected by the following temperature and humidity extremes: -29° to 74° C (20° to 165°F) when the relative humidity is 0-50%; -29° to 57°C (-20° to 135°F) when the relative humidity is 0-95%. Dimensions shall be 363 mm (14. 3 in. ) long (PC Plus 12), and 516 mm (20. 3 in. ) long, (Pc Plus-18) with a maximum head diameter of 14. 6 mm (0. 58 in). The PC Plus-12 microphone shall include a 305 mm (12 in. ) gooseneck. The PC Plus-18 microphone shall include a 457 mm (18 in. ) gooseneck. The gooseneck will be attached to a miniature base that has a top mounted push-button, and a status LED that lights when audio is active. The push-button will be configurable for push on/off, or push-to-mute operation. Furthermore, when the push-button is set for push on/off operation, the status of the microphone when power is initially applied, will be configurable. The miniature base will have an integral 3-pin XLR connector. The lower section housing of the miniature base will be removable to facilitate flush mounting of the microphone on a flat surface and appropriate hardware will be supplied for this purpose. The microphone will have a switchable high pass filter to roll off low frequencies. All controls except for the push button will be only accessible from the bottom of the microphone base. [. . . ] For Technical Assistance, contact Technical Support at 800/234-6831 or 616/695-6831, M-F, 8:00 a. m. Specifications subject to change without notice. For customer orders, contact Customer Service at: 800/392-3497 Fax: 800/955-6831 Europe, Africa, and Middle East only. [. . . ]