User manual ELECTRO-VOICE RE-1

[. . . ] Operating Instructions RE-1 User Guide Table of Contents Quick Set-Up . 3-1 CSR-1000 Receiver Controls, Connectors and Indicators . 3-1 CSR-1000 Receiver Setup and Operation . 3-4 CSH-1000 Handheld Transmitter Setup and Operation . [. . . ] If this Group/Channel is blank you will see '---. ---' on the frequency display. (Blank channels also display a '-' after the channel number on the Group/Channel screen). Press SET and use the UP or DOWN buttons to change the frequency. Press SET to save the new frequency, or MENU to quit without saving changes since SET was last pressed. Power Switch Disable: When the Power Switch is disabled, you must move the power switch to the OFF position and then press a control key (MENU, SET, UP or DOWN) to power the unit off. To engage a one-time power switch lock: Turn the unit on. After the display shows Group & Channel, quickly turn the power off and on three times. "On-Loc" will show on the display. A One-time lock disables itself the next time the unit is turned on. To always lock the power switch ON, press and hold SET, then press UP. "On-Loc" will show on the display. Battery Gauge: Display 3 seconds Group Channel Press MENU Frequency Display Press MENU Battery Gauge Press MENU To disable Power Lock, press and hold SET, then press DOWN. "On-Off" will show on the display. The unit can now be turned off with just the power switch. Firmware Revision Level: Battery Indicator: Battery condition is displayed on power up. The low battery LED should flash once to indicate an acceptable battery. If the battery is nearly depleated, the low battery LED will come on and stay on. When battery voltage is too low for proper microphone operation, the low battery LED will flash continuously and the unit will not transmit. You can check battery condition at any time by pressing the MENU button twice from the Group/Channel display screen. Battery condition is also displayed at the receiver. Group and Channel Setting: Transmitter frequencies are divided into 20 Groups of 16 frequencies (or Channels). Frequency Groups 1 through 10 are predefined and cannot be changed. Frequency Groups 11u through 20u can be set by the user. [. . . ] Seal it with gummed paper tape, tie it with a strong cord, and ship it by prepaid express, United Parcel Service or insured parcel post to the Telex Service Department. It is very important that the shipment be well-packed and fully insured. Damage claims must be settled between you and the carrier and this can delay repair and return of the unit to you. Telex reserves the right to make changes in design and improvement on its product without assuming any obligation to install the same on any of its products previously manufactured. [. . . ]