User manual ELECTRO-VOICE S-40MB EDS

[. . . ] S-40MB Mounting Bracket Kit Wall Mounting Instructions 1. Refer to Figure 1 for the following steps. [. . . ] Attach the second Friction Pad in a similar manner. Screw the U-Bracket assembly onto the mic stand using the threaded middle hole on the U-Bracket. Snug the mic stand locking nut on the bottom side of the bracket to prevent it from moving. Remove the two plastic hole plugs from each end of the S-40 speaker by gently prying with a small screwdriver. Place a Nylon Washer (D) on the threaded stud of each of the Torque Knobs (B). Mount the S-40 speaker to the UBracket using the Torque Knobs and Nylon Washers. Rotate the speaker so that the input panel is accessible and attach the wires to the input panel. Position the speaker for the desired coverage and gently tighten the Torque Knobs. Item A B C D Quantity 1 2 2 2 Description U-Bracket Torque Knob Friction Pad Nylon Washer Limited Warranty Electro-Voice products are guaranteed against malfunction due to defects in materials or workmanship for a specified period, as noted in the individual product-line statement(s) below, or in the individual product data sheet or owner's manual, beginning with the date of original purchase. If such malfunction occurs during the specified period, the product will be repaired or replaced (at our option) without charge. The product will be returned to the customer prepaid. [. . . ] For technical assistance, contact Technical Support at 800/234-6831 or 616/695-6831, M-F, 8:00 a. m. Specifications subject to change without notice. S-40MB Mounting Bracket Kit FIGURE 1-- Wall Mounting FIGURE 2--Stand Mounting 600 Cecil Street, Buchanan, MI 49107 616/695-6831, 616/695-1304 Fax ACCESSORIES--Speaker Accessories ©EVI Audio 1999 · Litho in U. S. A. [. . . ]