User manual ELECTRO-VOICE T18 EDS

[. . . ] The T18 EDS provides a wireless link between your calibrated measurement microphone and audio analyzer. [. . . ] That means you can quickly test multiple locations from the front row to the nosebleed seats in the time it would take to haul long mic cables to just one spot. · Wireless link between test microphone and audio analyzer allows faster, easier measurement of large performance spaces · Optional 48V phantom power supply works with any measurement microphone · Non-companded transmission does not affect audio quality The key feature of the T18 EDS is that it defeats the compander on both the receiver and bodypack transmitter. Wireless mic systems normally use companding (compressing/expanding) to stuff more dynamic range through narrow wireless channels. The T18 EDS system includes a bodypack transmitter in a rugged cast magnesium case with a mic stand mounting strap and a TA4F-to-XLR adapter cable to accommodate most calibrated microphones. The T18 EDS receiver includes two detachable 1/4-wave antennas, and can be rack-mounted with optional hardware. T18 EDS System · Mounting strap · TA4F-to-XLR adapter cable · AC Adapter (as pictured at right) T18 EDS Receiver Controls Front Panel: Rear Panel: Indicators Diversity Lights: Audio Meter: RF Meter: Connectors Antennas RF Specifications Frequency: Diversity: RF Sensitivity: FCC type acceptance: Audio Specifications Frequency Response: Audio Output Level: Distortion: Dynamic Range: Audio Specifications Signal to Noise Ratio: Power On/Off Group, Channel, Frequency Indicates antenna phase relationship Shows audio signal level from the transmitter Shows the RF signal strength XLR balanced output Detachable 1/4- wave ground independent 722-746 mHz Full True Diversity <0. 5uV for 12 dB SINAD Approved under Part 15 (compander active) 30 Hz ­ 15 kHz ± 1 dB -50 dBm to ­10 dBm into 200 Less that 0. 5% 100 dB (compander inactive) 57 dB typical T18 EDS Transmitter T18 EDS Transmitter is shown with the mounting strap and cable adapter. [. . . ] The T18 EDS receiver includes two detachable 1/4-wave antennas, and can be rack-mounted with optional hardware. T18 EDS System · Mounting strap · TA4F-to-XLR adapter cable · AC Adapter (as pictured at right) T18 EDS Receiver Controls Front Panel: Rear Panel: Indicators Diversity Lights: Audio Meter: RF Meter: Connectors Antennas RF Specifications Frequency: Diversity: RF Sensitivity: FCC type acceptance: Audio Specifications Frequency Response: Audio Output Level: Distortion: Dynamic Range: Audio Specifications Signal to Noise Ratio: Power On/Off Group, Channel, Frequency Indicates antenna phase relationship Shows audio signal level from the transmitter Shows the RF signal strength XLR balanced output Detachable 1/4- wave ground independent 722-746 mHz Full True Diversity <0. 5uV for 12 dB SINAD Approved under Part 15 (compander active) 30 Hz ­ 15 kHz ± 1 dB -50 dBm to ­10 dBm into 200 Less that 0. 5% 100 dB (compander inactive) 57 dB typical T18 EDS Transmitter T18 EDS Transmitter is shown with the mounting strap and cable adapter. [. . . ]